Kenmore Washer 110.6204754 (1106204754, 110 6204754) Parts

Leaking water connection? This hose coupling creates a secure seal between your washer hose and water inlet, stopping drips and loose connections. DIY fix.

This screw-washer assembly secures panels, brackets, and other appliance components. The integrated washer spreads load and resists loosening, so replacing a worn or missing fastener restores a tight, reliable fit and helps eliminate rattles.

• Provides fastening with a built-in washer for even clamping and retention
• Replaces missing, stripped, or corroded hardware
• Helps address loose panels/handles and vibration or rattle noises
• Supports proper alignment of covers, brackets, and trim

• Disconnect power and shut off water or gas (as applicable) before servicing
• Match to the original fastener; location and quantity in your model's parts diagram
• Start threads by hand to avoid cross-threading; tighten with the correct driver
• Do not overtighten; replace other severely rusted or damaged fasteners in the same area

This bearing supports the spin basket (inner tub) in top-load washers, allowing it to rotate smoothly during the spin cycle. It is mounted at the base of the spin basket and bears the load of the drum and its contents. Replace this bearing if the washer makes loud grinding or squealing noises during the spin cycle, if the basket wobbles excessively, or if you notice water leaking from beneath the tub.

Supports the washer transmission shaft to reduce axial wear and noise. Replace when you hear grinding sounds or experience rough operation. Confirm fit with your model number.

Fix a washer that won't change water temperature or cycles incorrectly with this water temperature switch. Simple repair restores proper wash cycle control.

Upper drain hose with elbow fitting for washers. Replaces cracked, leaking, or damaged drain hoses that cause water drainage issues during wash cycles.

Replace your washer's drain hose when cracked, kinked, or leaking. This tube connects the pump to the drain outlet, routing wastewater out of the machine.

Size: 6 foot. This washer fill hose can be used for the hot or cold.

Replace your washer's 5/16-18 hex nut if the original is stripped, missing, or corroded. Secures components during assembly and maintenance.

4 port. Whirlpool and Kenmore washers.