Kenmore Washer 110.6605971 (1106605971, 110 6605971) Parts

Size: 6 foot long. Washers not included. This is one hose, for a set with washers order 285363. For inlet hose screen use 285452A and for inlet hose washers use 285448A

This connector hose links appliance plumbing components to restore a sealed water path and proper flow. It replaces a damaged or leaking hose section so the appliance can refill and drain as intended. What it does:

• Re-establishes a sealed hose connection between intake/drain plumbing points
• Prevents leaks caused by cracked, split, or worn hose fittings
• Helps restore normal water fill or drain behavior when the original connector fails
• Compatible with the factory connection points shown in the OEM parts diagram

• Turn off power and shut off the water supply before starting work
• Inspect adjacent clamps and fittings; replace any damaged hardware for a secure seal
• Use proper hose clamps and ensure connections are tight but not over-torqued

Replace your washer's 5/16-18 hex nut if the original is stripped, missing, or corroded. Secures components during assembly and maintenance.

This 15-way terminal plug provides the wire-to-wire connection used on select appliance control assemblies, restoring secure electrical connections and reliable signal/power routing. Fits into the matching terminal block for proper electrical contact. What it does:

• Re-establishes a 15-position connector between wiring harness and control/terminal block
• Helps stop intermittent operation caused by loose, damaged, or corroded plug connections
• Ensures correct routing of power and control signals when mating terminals are secure
• Used wherever a 15-way plug interface is specified on the appliance wiring harness

• One 15-way terminal plug

• Disconnect power to the appliance before servicing to avoid shock or injury
• Handle terminals and wires gently to avoid bending or damaging contacts
• Confirm plug orientation and full seating into the mating terminal block during installation
• If mating terminals or wiring are damaged or corroded, replace those components as well

4 port. Whirlpool and Kenmore washers.

The tub ring clip is a small plastic or metal fastener that secures the tub ring to the outer tub of a washing machine, holding the two components together during the wash cycle. It prevents the tub ring from shifting or separating under the vibration of spinning and agitation. Replace it if you notice the tub ring is loose, rattling during cycles, or has come free from its mounting position.

Includes 4 rubber washers, 4 metal washers, and 4 screws.