Kenmore Dryer 110.6907200 (1106907200, 110 6907200) Parts

Protective cover that shields the manifold assembly from dust and debris. Replace if cracked, broken, or missing to restore a secure, finished look.

Replacement drum front bulkhead for dryers. Installs at the front of the drum assembly. Needed when original is cracked, damaged, or worn out.

Compression nut for dryer installation. Secures hoses and connections. Replace if stripped, corroded, or missing to ensure proper assembly and fit.

Lint chute directs lint and debris from the dryer drum to the lint screen. Replace if cracked, broken, or clogged to maintain proper airflow.

Ground wire clip for ranges and ovens. Secures grounding wire to chassis. Replace if clip is broken, bent, or missing to ensure proper electrical ground.

Tail pipe for dryer stack kit installation. Connects stacked dryer to water supply or drain. Replace if cracked, leaking, or missing from kit.

Dryer not heating? A faulty gas valve assembly often causes no heat or inconsistent heating. Moderately difficult repair requiring basic tools and safety.

Seals unused pipe openings in your washer to prevent leaks and debris entry. Replace if damaged, cracked, or leaking to restore watertight closure.

Hinge pad cushions the dryer door hinge connection. Replace if your original pad is cracked, worn, compressed, or missing to restore proper door support.

Gas dryer not heating or flame too low? A clogged or wrong-size gas orifice restricts fuel flow. Simple 10-minute fix restores proper heat output.

Secures hoses to prevent leaks in your washer. Replace if loose, cracked, or causing water leakage. Verify compatibility with your model number.

This kit secures the lower toe/kick panel to the front of the appliance, keeping the panel tight and properly aligned. Replacing worn or missing clips restores a secure fit and makes access for service straightforward.

• Holds the toe/kick panel in place at the base of the cabinet
• Helps prevent panel rattling, gaps, or a loose/hinging lower panel
• Common fix when the lower panel won't stay secured after service
• Durable metal clip design for repeated panel removal and reattachment

• Unplug appliance before servicing; wear gloves to avoid sharp edges
• Support the toe panel while releasing old clips to prevent bending
• Install clips in the cabinet slots first, then engage the panel into the clips
• Verify the panel is fully seated on both sides before restoring power

L205-40. Dryer

Right side

This left-side guide cable helps position and stabilize the appliance component it supports, restoring smooth movement and alignment for reliable operation. Designed to replace a worn or broken guide cable and reduce binding or misalignment. What it does:

• Guides and supports the component assembly on the left side to maintain correct travel and alignment
• Replaces damaged or frayed cable that can cause sticking, jerking, or uneven movement
• Helps restore smooth operation and consistent performance of the guided assembly
• Works as the matching left-side counterpart when paired with its right-side guide

• One left-side guide cable

• Follow the appliance manufacturer's service instructions and disconnect power before beginning work
• Handle cable ends and attachment points carefully to avoid fraying or damage during installation
• Verify routing and attachment points match the original cable for correct operation