Kenmore Dryer 110.86874100 (11086874100, 110 86874100) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: 279220
Includes two bumpers and two locking clips. You will use one or the other depending on hole size.
Do-It-Yourself Stories from Customers like You
Gas dryer did not heat and excessive lint inside the unit James C. • New Boston , MI • July 20, 2017
Our 19 year old Whirlpool dryer quit heating. After checking the thermal fuse, I found the ignitor electrically open. I bought an ignitor at a local store as there was a national holiday the next day and I did not want the dryer inoperative waiting several days for shipping. I can say AppliancePartsPros is MUCH cheaper for the identical Whirlpool genuine part. While changing the ignitor, I noticed there was an excessive amount of lint in the dryer, which was caused by worn drum seals. I ordered...
Read more
More
$12.32
- Compare At:
-
$14.54
- You Save:
-
$2.22
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3388703
This flat support washer provides a stable bearing surface under a fastener. Its 1-1/2-in diameter helps distribute load, maintain spacing, and keep components aligned so hardware stays tight and assemblies operate smoothly. What it does:
- Distributes clamping force to prevent pull-through and gouging
- Maintains proper spacing and alignment between mating parts
- Helps reduce vibration, rubbing, or wobble from a loose assembly
- Replaces a cracked, deformed, or missing support washer
What's included:
Install notes:
- Disconnect power and shut off water/gas before servicing.
- Note the order and orientation of any washers/spacers during disassembly.
- Inspect mating hardware and surfaces; replace any worn or damaged parts.
- Tighten fasteners to manufacturer specifications—do not over-tighten.
Do-It-Yourself Stories from Customers like You
Drum support bearing failure. Myron D. • Covington , KY • July 13, 2018
Simple fix, right parts fast.
Read more
More
$4.95
- Compare At:
-
$5.89
- You Save:
-
$0.94
Genuine Whirlpool part
By: Whirlpool
Part Number: 279872
This fixed-value resistor is an electrical component used in select dryers to limit current in a specific control circuit. It helps the timer or electronic control operate correctly by dropping voltage to safe, design-intended levels.
- Provides precise resistance to reduce voltage/current in the designated dryer circuit
- Supports proper operation of the timer, control board, or end-of-cycle signal (varies by model)
- Failure may present as a timer that won't advance, an inoperative signal/buzzer, or irregular cycle behavior
- Replace if visibly burned/damaged or if testing shows an open or shorted condition
What's included: One resistor Install notes:
- Disconnect power to the appliance before servicing
- Access the console/wiring harness and note original wire routing
- Make secure, insulated connections and route the resistor/leads exactly as original to avoid heat or chafing
- After installation, run a test cycle to ensure proper operation of the affected function
Do-It-Yourself Stories from Customers like You
Timer wouldn't advance on my dryer John L. • Oblong , IL • March 22, 2016
I ordered a new timer and installed it with the help of the videos provided and this did not solve my problem so I chated with the pros @ Appliance Parts Pros and told them my problem and they told me the problem and recommended the part I needed and With the incredibly fast shipping I had the part the next day. I installed it and now my dryer timer works great.Thanks to APPs for their help and ease of ordering and fast shipping. I highly recommend AppliancePartPros and will definitely use...
Read more
More
$45.28
- Compare At:
-
$54.34
- You Save:
-
$9.06
Genuine Whirlpool part
By: Whirlpool
Part Number: WP357213
Push-in.
Do-It-Yourself Stories from Customers like You
Washer would fill with water and then do nothing else Richard C. • Torrance , CA • December 05, 2015
I saw videos on it possibly being the lid switch. I used 2 lead wires to bypass the lid switch, which indicated it was indeed the lid switch that was faulty.
I ordered the lid switch, which came in 2 days. I installed it in less than 7 minutes.
Read more
More
$5.95
- Compare At:
-
$7.14
- You Save:
-
$1.19
Genuine Whirlpool part
By: Whirlpool
Part Number: W11233063
Factory protective shield panel for dryer assembly. Guards internal components and directs heat or airflow. Replace if cracked, broken, or missing.
Do-It-Yourself Stories from Customers like You
The seals were worn. Anthony C. • Bentonia , MS • November 14, 2023
I changed the thermostat and replaced the worn out seals.
Read more
More
$14.56
- Compare At:
-
$17.18
- You Save:
-
$2.62
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489069
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
Do-It-Yourself Stories from Customers like You
Broken handle foot pedal and missing parts Donald M. • Lake Arrowhead , CA • April 05, 2015
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy!
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP692490
Plastic drum baffle that lifts and tumbles clothes during drying. Replace if cracked, broken, detached, or missing from inside your dryer drum.
Do-It-Yourself Stories from Customers like You
Baffle detached stripped screw holes Judith R. • Chandler , AZ • August 09, 2014
I installed it my self by watching your video
Read more
More
$70.34
- Compare At:
-
$83.70
- You Save:
-
$13.36
Genuine Whirlpool part
By: Whirlpool
Part Number: W11684613
Replace a cracked or missing bracket to keep appliance components securely mounted and aligned. Restoring this support helps prevent movement, vibration, and premature wear, so the connected part operates as intended.
- Provides a rigid mounting point for an associated component or assembly
- Maintains correct alignment and spacing within the appliance
- Helps reduce vibration, rattling, or shifting during operation
- Replaces brackets that are cracked, bent, or broken
- Common signs: loose or wobbly parts, misalignment, rattling noises, or visible bracket damage
What's included: 1 bracket Installation notes:
- Disconnect power; also shut off the water supply before servicing
- Wear cut-resistant gloves—bracket edges can be sharp
- Reuse original screws/clips unless replacements are specified
- Hand-start fasteners, align parts, and tighten evenly without overtightening
Do-It-Yourself Stories from Customers like You
Drive belt support rollers and idler pulley worn. Carlos W. • Port Orchard , WA • May 30, 2020
Disassembled dryer, replaced worn parts and reassembled dryer.
Removed top cover, disconnected front connector, removed front panel, removed belt from idler pulley, removed washer drum and belt, replaced push clip, retaining clips, 2 support rollers and idler pulley. Reassembled in reverse order.
Read more
More
$17.95
- Compare At:
-
$21.36
- You Save:
-
$3.41
Genuine Whirlpool part
By: Whirlpool
Part Number: W11693756
Type AB #8-18 x 5/8 inch thread-forming screw secures panels and components in appliances. Replace missing, stripped, or corroded fasteners.
Do-It-Yourself Stories from Customers like You
Door switch on dryer. James A. • Middleburg , FL • January 20, 2020
It was very easy to fix after watching your video..
Read more
More
$10.95
- Compare At:
-
$12.92
- You Save:
-
$1.97
Genuine Whirlpool part
By: Whirlpool
Part Number: W11736322
This replacement cover restores the appliance's finished appearance and protects internal components from dust and debris. It's a direct-fit exterior trim piece designed to replace a cracked, broken, or missing cover. What it does:
- Protects internal components and wiring from debris and accidental contact
- Restores the appliance's cosmetic appearance and helps maintain sealing
- Helps reduce dust buildup in the covered area
- Replaces damaged or missing trim that can expose sharp edges or hardware
What's included: One outer cover Install notes:
- Disconnect power (unplug or switch off circuit breaker) before beginning work
- Basic hand tools may be required; follow for panel removal/replacement
- Handle carefully to avoid scratching the finish and watch for sharp edges
- Replace with manufacturer-recommended fasteners
Do-It-Yourself Stories from Customers like You
Broken coupling half Neal F. • W Portsmouth , OH • February 27, 2026
Replaced broken coupling with new coupling
Read more
More
$27.95
- Compare At:
-
$33.20
- You Save:
-
$5.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8066217
Supports and pivots the hinged dryer top panel for service access. Replace if cracked, broken, or causing wobble, scraping, or alignment gaps.
Do-It-Yourself Stories from Customers like You
Dryer wouldn't heat up. John B. • Dundalk , MD • January 19, 2020
Installed a new Ignitor & Thermal Fuse.
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3403636
Short baffle that mounts inside the dryer drum to lift clothes as the drum rotates. Replace if cracked, broken, or missing for proper tumbling action.
Do-It-Yourself Stories from Customers like You
The dryer will me a buzzing but wouldn't turn Jose B. • Berkeley , CA • April 02, 2017
I watched You Tube and it gave me an idea of what was was wrong.. The motor was frozen. There was not room here to comment about the service that I received . It is only one word fantastic, from the time I started chat with the rep to the time I finished. Amazing. I order the part on Tuesday and I received the parts on Wednesday. That night when I came back from work, I fixed . Everybody at home was happy that the dryer was back in business. Thank you guys and the amazing Representative that...
Read more
More
$64.22
- Compare At:
-
$77.06
- You Save:
-
$12.84
Genuine Whirlpool part
By: Whirlpool
Part Number: WP694419
This adjustable buzzer kit replaces a failed or noisy mini buzzer to restore audible alerts for cycles, timers and notifications. Compact design lets the appliance signal you reliably when cycles finish or need attention. What it does:
- Produces audible tones for cycle end, timers and other appliance notifications
- Replaces buzzers that are silent, intermittent, weak or emitting erratic beeps
- Helps you hear and identify completed cycles and timed alerts
- Small, mountable unit that fits behind the control panel and connects to the control board
What's included:
- One adjustable buzzer kit
Install notes:
- Disconnect power before servicing to avoid shock risk
- Access may require removing the control panel; keep fasteners organized for reassembly
- Disconnect the buzzer wiring harness or connector before removing the old unit; connect the new buzzer the same way
- Test buzzer function with power restored before fully reassembling
Do-It-Yourself Stories from Customers like You
Replaced buzzer and heating element. Charles B. • Sioux Falls , SD • August 26, 2018
I watched the repair video AppliancePartsPros.com had on each repair and followed the instructions.
Read more
More
$70.34
- Compare At:
-
$84.41
- You Save:
-
$14.07
Genuine Whirlpool part
By: Whirlpool
Part Number: 350956
Almond. Size: 13 oz. can. Acrylic appliance paint.
Do-It-Yourself Stories from Customers like You
Age no money to fix it Ronald V. • Cape Coral , FL • August 01, 2015
Was able to match it pretty well the natural age difference was good. The delivery of the product was amazing it took less than 24 hours to get to me and that was standard shipping. Give you guys an A for great !!
Read more
More
$30.52
- Compare At:
-
$36.32
- You Save:
-
$5.80
Genuine Whirlpool part
By: Whirlpool
Part Number: WP72107
Touch-up paint for appliances in almond color. Repairs chips, scratches, and worn spots on ovens, refrigerators, microwaves, and dryers.
Do-It-Yourself Stories from Customers like You
Broken meat drawer Jesse B. • Stow , MA • January 26, 2015
Replaced. Shippping was very fast. A good experience.
Read more
More
$14.66
- Compare At:
-
$17.30
- You Save:
-
$2.64
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10041960
This door spring restores the proper counterbalance of the oven door so it opens smoothly and closes with controlled tension. Replacing a worn or broken spring helps prevent the door from dropping, slamming, or sitting unevenly.
- Provides counterbalance tension for the oven door through the hinge mechanism
- Helps the door open smoothly and hold at a partially open position
- Maintains even alignment and consistent gasket contact
- Common symptoms of failure: door feels heavy, drops open or slams, uneven door height, squeaks during movement
What's included: One door spring. Install notes:
- Disconnect power at the breaker and allow the oven to cool completely
- Springs are under tension—support the door and use caution to avoid injury
- Note the spring's routing and anchor points before removal; reinstall in the same positions
- For even tension, consider replacing both door springs when the design uses one per side
Do-It-Yourself Stories from Customers like You
Door would not stay closed. Mark B. • Greenfield , WI • January 05, 2020
Purchased the above kit to repair the door hardware. Also had to purchase door hinges to replace one I found broken after disassembling the dryer front. Parts arrived as shown in the online pictures, and arrived within 4-5 business days.
Read more
More
$26.60
- Compare At:
-
$31.39
- You Save:
-
$4.79