Whirlpool 279220 Clip Kit OEM Part

Our 19 year old Whirlpool dryer quit heating. After checking the thermal fuse, I found the ignitor electrically open. I bought an ignitor at a local store as there was a national holiday the next day and I did not want the dryer inoperative waiting several days for shipping. I can say AppliancePartsPros is MUCH cheaper for the identical Whirlpool genuine part. While changing the ignitor, I noticed there was an excessive amount of lint in the dryer, which was caused by worn drum seals. I ordered drum seals, a new drive belt, the foam seals for the exhaust duct and new nylon drum bearing set. These were delivered promptly, but unfortunately the 2-piece nylon drum bearing set had only 1 piece. I went on line, used the chat function and was promptly taken care of. The new part arrived fairly quickly, was correct and I installed it. The most difficult part of the project was the rear drum seal which must be glued to the drum. I removed the old seal and sanded off the dried glue. I then set the drum up on a work table, blocked from rolling off with 2x4s, so I could rotate it in place. The new seal needs to be stretched to make it around the drum circumference, so I used small wood clamps to hold it in place around the drum. I then pushed back the fabric, applied a small bead of glue to the drum surface, gave it about a minute to air dry, then repositioned the seal. I worked my way around the drum, rotating it on my work table. The seal installed nicely. Pay attention when you position the drum during final assembly so that the rear support rollers are in place and the seal correctly circles the stationary back wall for the drum. You can check the seal for folding bouth outside and inside. 2 people are advised for this step. One last note, the installation of the drive belt is little tricky, so photograph the belt path through the tensioner and motor drive pulley before you remove the old belt.

This ended up being very simple thanks to the wonderful videos on Appliance Parts Pros. We just followed the directions and had no problems at all. Including videos with parts is a great way to do business! Quick notes: 1. I used an oscillating scraper and a Dremel tool wire brush to quickly remove the glue from the old felt drum seal. 2. A shop vac is very useful any time you open up the drier.