Kenmore Dryer 110.97565110 (11097565110, 110 97565110) Parts

This part is a motor clamp. This is a genuine OEM part and has been sourced directly from the manufacturer. This part is intended to replace a deteriorated, damaged, or broken motor clamp on certain makes of indoor appliance models. Motor clamps are essen

Includes two bumpers and two locking clips. You will use one or the other depending on hole size.

This flat support washer provides a stable bearing surface under a fastener. Its 1-1/2-in diameter helps distribute load, maintain spacing, and keep components aligned so hardware stays tight and assemblies operate smoothly. What it does:

• Distri
  Do-It-Yourself Stories from Customers like You Drum support bearing failure.   Myron D. • Covington , KY • July 13, 2018

  Simple fix, right parts fast. Read more

Push-in.

Dryer won't shut off or cycles won't advance? This 3-cycle timer controls cycle selection and automatic shut-off. DIY-friendly, 8-15 minute fix.

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

Factory protective shield panel for dryer assembly. Guards internal components and directs heat or airflow. Replace if cracked, broken, or missing.

This power cord connects your appliance to household electricity, supplying safe, reliable power to its controls and components. Replace a damaged or overheated cord to restore dependable operation and reduce the risk of shorts.

• Supplies AC powe
  Do-It-Yourself Stories from Customers like You New cord   Michael C. • Bakersfield , CA • May 10, 2021

  Thanks to you, all went well. No problems. Read more

Type AB #8-18 x 5/8 inch thread-forming screw secures panels and components in appliances. Replace missing, stripped, or corroded fasteners.

This replacement cover restores the appliance's finished appearance and protects internal components from dust and debris. It's a direct-fit exterior trim piece designed to replace a cracked, broken, or missing cover. What it does:

• Protects inte
  Do-It-Yourself Stories from Customers like You Broken coupling half   Neal F. • W Portsmouth , OH • February 27, 2026

  Replaced broken coupling with new coupling Read more

Supports and pivots the hinged dryer top panel for service access. Replace if cracked, broken, or causing wobble, scraping, or alignment gaps.

Replacement screw secures panels, brackets, and internal assemblies. Needed when original hardware is stripped, corroded, or missing to keep parts tight.

Door hinge pin assembly for dryers. Provides the pivot point for your dryer door, supporting its weight during opening and closing. Replace if bent or worn.

This flat-head screw secures panels, brackets, or trim so they sit flush on your appliance. Replacing a worn or missing screw restores a tight fit and helps prevent vibration, rattling, or shifting components.

• Provides a countersunk, flush-mount

Almond. Size: 13 oz. can. Acrylic appliance paint.

Vinyl door seal lines the dryer door perimeter to block air leaks and cushion closure. Replace when worn or cracked to restore a tight seal. Verify fit by model.