Kenmore Range Hood 233.59940590 (23359940590, 233 59940590) Parts

Crank assembly for range hood vent systems. Replaces broken or worn crank mechanisms that control vent opening and closing. Direct fit replacement part.

Replacement mounting plate for range hood assemblies. Secures and covers internal components while providing a finished trim. Needed when original is cracked, broken, or missing.

Mounting screw for range hood installation and assembly. Replace missing, stripped, or damaged screws to secure housing panels and components properly.

Replacement bolt for range hood and vent system assemblies. Secures panels, covers, or mounting brackets. Order if original hardware is stripped or missing.

This is a factory replacement part for Broan appliances. Use it to restore original operation when a specific component has failed or is missing — helps get your range/ventilation unit working like it did before. What it does:

• Replaces a failed factory component to restore normal appliance function
• Can address symptoms such as loss of operation, intermittent operation, or abnormal noises when the missing/failed part is the cause
• Restores original fit where the OEM component is required for proper performance
• Preserves factory safety and operating characteristics when the correct part is installed

• Verify the part number on your appliance and that this is the correct replacement before installation
• Disconnect power (and gas if applicable) to the appliance before attempting any service
• Follow OEM service manual instructions for removal and installation; use appropriate tools and safety gear

A simple replacement wire tie designed to secure wiring and small components inside range hoods and ventilation units, helping keep wires organized and away from moving parts or heat sources for safer operation. What it does:

• Bundles and secures wiring to prevent loose harnesses from rubbing or snagging
• Keeps wires routed away from fan blades, heating elements, and sharp edges
• Reduces vibration-related wear on wire insulation and connectors
• Helps maintain a neat internal layout for easier future service

• One wire tie

• Use pliers or a cable-tie tool to tighten; trim excess tail flush with the locking head
• Inspect surrounding wiring for damage before securing; replace damaged wires or insulation first
• Avoid overtightening; cable ties should hold firmly without cutting into wire insulation
• Disconnect power to the appliance before accessing internal components

This bushing cushions and supports a range-hood motor shaft to restore smooth, quiet blower operation and reduce wear on rotating parts. It's a small replacement part used where the motor shaft passes through the housing. What it does:

• Centers and stabilizes the motor shaft to prevent wobble and vibration
• Reduces shaft-to-housing friction that can cause noise or premature wear
• Helps maintain proper blower alignment for consistent airflow
• Supports long-term motor and housing durability when installed correctly

• One bushing

• Disconnect power to the appliance before starting any repair
• Access the blower/motor housing; partial disassembly is usually required
• Inspect mating surfaces and replace any worn or damaged components at the same time
• Follow OEM instructions for placement; do not force the bushing into position

Replacement cover panel for range hood exterior. Protects internal components and completes the appearance. Order if your original is cracked or missing.