Kenmore Refrigerator 253.31612100 (25331612100, 253 31612100) Parts

Secures motor wiring in your refrigerator. Replace if adhesive fails or clamp breaks, causing loose wires. Confirm fit with your model number.

Center hinge bracket for refrigerators in bisque finish. Mounts between doors to support door alignment. Replace if cracked, broken, or worn.

This coil cover seal is a replacement gasket that fits around the evaporator/coil cover to help maintain an airtight seal and reduce frost and moisture buildup. It restores proper airflow control for more consistent cooling. What it does:

• Seals the coil/evaporator cover to limit warm, moist air entering the coil area
• Helps reduce frost or ice accumulation on the evaporator coil
• Supports efficient cooling and stable compartment temperatures
• Can stop short-cycling or extended run times caused by air leaks
• Prevents moisture intrusion that can lead to corrosion or odor issues

• Disconnect power to the appliance before beginning any repairs
• Remove any shelving or covers needed to access the evaporator/coil cover per your service instructions
• Clean mating surfaces and seat the seal fully around the coil cover for an even contact
• If adhesive is used, use OEM-recommended tape or adhesive and allow proper cure time before re-energizing

This complete white freezer door panel restores the exterior appearance of the freezer and replaces a dented, scratched, or damaged outer door skin for a clean, factory look. Installs as a direct replacement for the outer door panel assembly. What it does:

• Replaces a dented, cracked, or cosmetically damaged freezer door outer panel
• Restores finished appearance and protects the underlying door structure
• Helps maintain proper door alignment and fit when the outer skin is compromised
• Matches factory exterior finish for a consistent look

• Disconnect power to the appliance before starting any repair
• Remove freezer door contents and place on a protected surface; door may need to be removed for easier installation
• Use appropriate hand tools and keep fasteners for reinstallation; follow factory instructions where available
• Have an assistant available for handling and aligning the door panel to avoid damage or injury

Secures and protects wiring harness from strain damage. Replace if cracked, broken, or wires show wear. Verify fit with your model number listed.

Replace a loose or missing extension lock washer causing rattling noises or unstable component mounting. Simple DIY fix in under 15 minutes.