Kenmore Refrigerator 253.44512609 (25344512609, 253 44512609) Parts

Covers the factory test opening on your refrigerator cabinet or liner. Replace if missing, cracked, or damaged to restore a finished look and seal.

Specs: 1.40`` long

Fridge not cooling or making loud buzzing noise? This compressor kit restores cooling in refrigerators and freezers. Professional repair recommended.

Forms an airtight seal between freezer door and cabinet. Replace when worn or damaged to prevent warm air leaks, frost buildup, and temperature issues.

Secures ice crusher components in place. Replace if pin is worn, missing, or broken to restore proper alignment and operation of crusher assembly.

Replacement fill tube that directs water from the inlet valve into your refrigerator's icemaker mold. Replace if cracked, damaged, or causing leaks.

This kickplate grille mounts across the bottom front of your refrigerator, covering the lower opening. Replace if cracked, broken, or missing.

This door hinge pin forms the pivot for the refrigerator door hinge, keeping the door supported and aligned. Replacing a worn or missing pin restores smooth door movement and consistent sealing.

• Acts as the hinge's pivot shaft to support the doo
  Do-It-Yourself Stories from Customers like You Ice maker/dispenser door bracket broken.   Michael R. • Windsor , CO • August 01, 2021

  With the necessary parts in hand from Appliance Parts Pros. By watching youtube, we saved CONSIDERABLE $ in repair/service calls. Read more

Replacement drip pan that captures defrost runoff and other liquids beneath the appliance, helping prevent puddles and odors. Fits into the base to restore proper fluid collection and reduce leaks. What it does:

• Collects and channels moisture an
  Do-It-Yourself Stories from Customers like You The shelf had cracked in the middle and the drawer had broken where the glide inserts   Ben W. • Marietta , GA • July 20, 2025

  I pulled out the drawer and set it aside, took out the shelf, took the brackets off the original shelf to remount the drawer, put the assembly back in and remounted the drawer to the brackets. It only took more than 15 minutes because I took the opportunity to clean those hart to reach spots while I had it apart. Read more

Refrigerator spacer maintains proper clearance and alignment between internal parts. Replace if worn, missing, or causing parts to rub or bind together.

This E-ring is a small retaining clip used in Frigidaire refrigerators to hold components on a grooved shaft or pin. It keeps assemblies secure and operating smoothly by preventing parts from sliding off during normal use. What it does:

• Retains
  Do-It-Yourself Stories from Customers like You Ice maker auger was scraping side of ice dispenser housing and dropping shavings in my glasses of ice   Frank T. • Vancleave , MS • November 25, 2015

  Replaced auger nut , washer, and e-ring on end of auger. This allowed the auger to rotate correctly, and not "rub" the sides of the ice dispenser housing. Read more

Control rod spring for refrigerator ice maker shutoff arm. Restores proper tension to control ice production cycles. Replace if spring is missing, broken, or worn.

Factory fastener that secures panels, brackets, and internal components. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattling.

Secures panels, brackets, handles, and trim inside your refrigerator. Replace missing, stripped, or damaged screws to eliminate rattling and looseness.

Replacement screw for refrigerator panels, brackets, and covers. Secures interior and exterior components. Needed when original is missing, stripped, or corroded.

Plastic grommet that supports and secures refrigerator shelves. Replaces broken, cracked, or missing grommets causing shelves to lean or sag.