Kenmore Refrigerator 253.50682001 (25350682001, 253 50682001) Parts

Fix a refrigerator that's not cooling properly or has ice buildup with a new evaporator coil. This part absorbs heat to keep your fridge cold.

Refrigerator not cooling or running too warm? A faulty thermostat prevents proper temperature regulation. This control cycles the compressor to maintain set temps.

Water tube insert sleeve for refrigerators. Fits inside water line connections to prevent leaks. Replace if cracked, damaged, or missing.

Replacement end cap support for refrigerator door racks. Secures and stabilizes door bins. Needed when original support is cracked, broken, or missing.

Endcap support bar for refrigerator door racks. Secures and stabilizes door bins. Replace if cracked, broken, or missing to restore proper door storage.

Ice dispenser door actuator wire for refrigerators. Connects the dispenser paddle to the ice door flap mechanism. Replace if broken, detached, or worn.

Refrigerator door bin versashelf that mounts inside the door to hold condiments, bottles, or eggs. Replace if cracked, broken, or missing from your unit.

Replacement screw for various appliances. Used to secure panels, components, or housing. Replace if stripped, corroded, missing, or damaged hardware.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation

Replaces your refrigerator's ice maker cover if cracked, broken, or missing. This protective cap installs on the ice maker assembly in your freezer.

Cut to fit design.

Seals evaporator coil cover to prevent air leaks and frost buildup. Replace when worn or damaged to restore efficient cooling. Confirm fit with model.