Kenmore Refrigerator 253.56972601 (25356972601, 253 56972601) Parts

This is a replacement mounting screw used to secure the defrost timer assembly to the refrigerator control housing, restoring proper fastening and preventing the timer from shifting or vibrating during operation. What it does:

• Secures the defrost timer to the control housing so the timer stays in position.
• Prevents vibration or movement that can cause intermittent contact or noisy operation.
• Helps maintain reliable defrost cycle timing by keeping the timer properly aligned.
• Addresses symptoms such as a loose or missing fastener, rattling behind the control panel, or a timer that shifts when the door is opened.

• Unplug the appliance before starting work to prevent electrical shock.
• Access the control housing or timer bracket per your model's service instructions.
• Use the correct screwdriver or driver bit; do not overtighten—stop when snug to avoid stripping.
• Retain removed hardware for reference and compare screw length/threads before installing.

Defrost drain trough for side-by-side refrigerators. Channels water from the freezer evaporator to the drain tube. Replace if cracked or broken.

Wiring harness that connects to the refrigerator door facade panel. Replace if harness is damaged, broken, or missing to restore electrical connections.

Hex head screw for securing refrigerator components and panels. Replace if stripped, missing, or damaged during appliance maintenance or repair work.

This is the replacement Energy Guide label that restores the factory efficiency and usage information inside your appliance. It provides the required estimated energy consumption and rating details in an easy-to-read adhesive format. What it does:

• Displays the appliance's estimated yearly energy use and operating cost for shopper comparison
• Replaces missing, damaged, or unreadable factory energy guide information
• Helps maintain resale value and compliance with consumer information expectations
• Non-electrical — informational only; does not affect appliance operation

• Clean and dry the mounting surface before applying for best adhesion
• Peel backing and press firmly, smoothing out air bubbles; allow adhesive to set
• Place label where original was located and where it is easily visible when the door is open
• Avoid applying near high-heat elements or in locations that receive heavy wear