Kenmore Refrigerator 253.56972603 (25356972603, 253 56972603) Parts

Defrost drain trough for side-by-side refrigerators. Channels water from the freezer evaporator to the drain tube. Replace if cracked or broken.

Wiring harness that connects to the refrigerator door facade panel. Replace if harness is damaged, broken, or missing to restore electrical connections.

This is the replacement Energy Guide label that restores the factory efficiency and usage information inside your appliance. It provides the required estimated energy consumption and rating details in an easy-to-read adhesive format. What it does:

• Displays the appliance's estimated yearly energy use and operating cost for shopper comparison
• Replaces missing, damaged, or unreadable factory energy guide information
• Helps maintain resale value and compliance with consumer information expectations
• Non-electrical — informational only; does not affect appliance operation

• Clean and dry the mounting surface before applying for best adhesion
• Peel backing and press firmly, smoothing out air bubbles; allow adhesive to set
• Place label where original was located and where it is easily visible when the door is open
• Avoid applying near high-heat elements or in locations that receive heavy wear

Secures and protects wiring harness from strain damage. Replace if cracked, broken, or wires show wear. Verify fit with your model number listed.

Mounting screw for freezer and refrigerator assembly. Secures panels, shelves, or internal components. Replace if stripped, missing, or damaged.

This name plate is the replacement identification label that mounts to the appliance exterior to display model, rating and manufacturing information — making it easier to identify and service the unit. What it does:

• Provides the factory identification label with model and rating details for accurate appliance identification
• Restores legibility when the original plate is scratched, faded or missing
• Helps technicians confirm correct replacement parts and service information
• Supports resale value and safety by ensuring required labeling is visible

• One replacement name plate

• Always disconnect power and shut off gas or water supply before servicing
• Clean and dry the mounting surface before installing to ensure proper adhesion or fit
• This part replaces the visible identification plate only; the part number on the plate matches your unit before installation
• If mounting hardware or adhesive is required, use the method specified by your model's service instructions