Kenmore Refrigerator 253.59482990 (25359482990, 253 59482990) Parts

White selector knob for refrigerator control panel. Replaces worn, cracked, or missing knobs that control temperature or settings. Direct-fit part.

Actuator spring for refrigerator solenoid mechanisms. Replaces broken or worn springs that cause poor movement or engagement. Restores tension.

Mounting bracket that secures the control rod to your refrigerator. Replace if the original bracket is cracked, broken, or missing to restore linkage.

Replacement mounting screw for refrigerators and ice makers. Secures internal components and panels. Order a new screw if original is stripped or missing.

Refrigerator not cooling or running too warm? A faulty thermostat prevents proper temperature regulation. This control cycles the compressor to maintain set temps.

Water tube insert sleeve for refrigerators. Fits inside water line connections to prevent leaks. Replace if cracked, damaged, or missing.

Replacement end cap support for refrigerator door racks. Secures and stabilizes door bins. Needed when original support is cracked, broken, or missing.

Endcap support bar for refrigerator door racks. Secures and stabilizes door bins. Replace if cracked, broken, or missing to restore proper door storage.

Fix a refrigerator that won't cool or run with this compressor overload protector. Prevents motor damage from electrical surges. Basic repair.

Ice dispenser door actuator wire for refrigerators. Connects the dispenser paddle to the ice door flap mechanism. Replace if broken, detached, or worn.

Replacement screw for various appliances. Used to secure panels, components, or housing. Replace if stripped, corroded, missing, or damaged hardware.

Ice maker not shutting off or making too much ice? A worn lever arm prevents proper shutoff. Simple replacement takes under an hour to restore function.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation