Kenmore Refrigerator 253.60721000 (25360721000, 253 60721000) Parts

This retainer lead wire secures appliance wiring to keep harnesses organized and away from heat or moving parts, reducing wear and accidental disconnection. It's a simple replacement to restore proper wire routing and protection. What it does:

• Clips or holds the wiring harness in place to prevent chafing and strain
• Helps keep wires away from hot surfaces, vents, or moving components
• Reduces risk of intermittent electrical connections caused by loose wiring
• Restores factory routing after service or component replacement

• Disconnect power to the appliance before installing to avoid shock or injury
• Remove any panels necessary to access the original retainer and wiring route
• Replace like-for-like, seating the retainer securely so the harness cannot shift
• If wires show damage or insulation wear, inspect further and replace damaged wiring before reassembly

This outer door panel replaces a damaged or worn exterior panel to restore the refrigerator door's appearance and structural coverage. It gives the door a finished exterior surface and supports attached trim and handle areas. What it does:

• Covers the exterior side of the refrigerator door and provides the finished outer surface.
• Restores damaged, dented, or scratched door exteriors for improved appearance.
• Supports attachment points for door trim, handle areas and exterior components.
• Helps protect internal door components from everyday bumps and wear.

• Disconnect power and empty the door before starting work; remove food and loose shelves.
• Typical installation requires removing the door handle and inner door liner to access mounting points.
• Handle panels, trim clips or screws are often removed/reinstalled during replacement; confirm whether existing fasteners are reusable.

Fix a refrigerator that won't cool or has a clicking compressor with this start relay and overload assembly. Common failure part, moderate DIY repair.

The Freezer Shelf is an OEM part for Frigidaire freezers. It provides additional storage space within the freezer, allowing for better organization and efficient use of the available space. The shelf measures approximately 14.5 x2 inches. 

Causes of a bad freezer shelf can include wear and tear from holding heavy items, accidental damage from dropping or mishandling, or warping due to temperature fluctuations. A compromised shelf can reduce storage capacity and potentially damage stored items.

Symptoms of a bad Freezer Shelf include:

• Cracks or breaks in the shelf
• Shelf not fitting securely or wobbling
• Difficulty in holding weight or sagging
• Warped or misshapen shelf

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.