Kenmore Refrigerator 253.61722011 (25361722011, 253 61722011) Parts

Foam insulation block that fills gaps inside the refrigerator cabinet to reduce heat transfer. Replaces damaged, compressed, or missing insulation.

Plastic plug insert for refrigerator panels and structural openings. Replace if cracked, broken, or missing to maintain proper cabinet appearance.

Replacement access cover panel for refrigerators. Closes service openings and protects internal components. Needed when original is cracked or missing.

Molded drain channel that guides defrost and condensation water to the drain system. Replace if cracked, broken, or leaking to prevent water damage.

Nameplate label for freezers and refrigerators. Mounts on exterior cabinet to display model information. Replace if faded, peeling, or missing.

This is a replacement mounting screw used to secure the defrost timer assembly to the refrigerator control housing, restoring proper fastening and preventing the timer from shifting or vibrating during operation. What it does:

• Secures the defrost timer to the control housing so the timer stays in position.
• Prevents vibration or movement that can cause intermittent contact or noisy operation.
• Helps maintain reliable defrost cycle timing by keeping the timer properly aligned.
• Addresses symptoms such as a loose or missing fastener, rattling behind the control panel, or a timer that shifts when the door is opened.

• Unplug the appliance before starting work to prevent electrical shock.
• Access the control housing or timer bracket per your model's service instructions.
• Use the correct screwdriver or driver bit; do not overtighten—stop when snug to avoid stripping.
• Retain removed hardware for reference and compare screw length/threads before installing.

This complete white freezer door panel restores the exterior appearance of the freezer and replaces a dented, scratched, or damaged outer door skin for a clean, factory look. Installs as a direct replacement for the outer door panel assembly. What it does:

• Replaces a dented, cracked, or cosmetically damaged freezer door outer panel
• Restores finished appearance and protects the underlying door structure
• Helps maintain proper door alignment and fit when the outer skin is compromised
• Matches factory exterior finish for a consistent look

• Disconnect power to the appliance before starting any repair
• Remove freezer door contents and place on a protected surface; door may need to be removed for easier installation
• Use appropriate hand tools and keep fasteners for reinstallation; follow factory instructions where available
• Have an assistant available for handling and aligning the door panel to avoid damage or injury

Official service data sheet with wiring diagrams and diagnostic references. Replace missing or damaged technical documentation for your appliance.

Plastic shelf cover that sits above the crisper drawers in your refrigerator. Replace if cracked, broken, or damaged to restore proper drawer support.

Replace a cracked, broken, or missing temperature control knob on your refrigerator. Installs on the control shaft to restore accurate temperature selection.

Control box housing for refrigerator electronic control boards. Replaces cracked, broken, or missing housings that protect the circuit board assembly.