Kenmore Refrigerator 253.61744010 (25361744010, 253 61744010) Parts

Foam insulation block that fills gaps inside the refrigerator cabinet to reduce heat transfer. Replaces damaged, compressed, or missing insulation.

Plastic plug insert for refrigerator panels and structural openings. Replace if cracked, broken, or missing to maintain proper cabinet appearance.

Refrigerator not cooling or running constantly? A faulty condenser coil prevents heat release. This repair requires moderate skill and 1-2 hours to complete.

Black lower front grille kickplate for refrigerators. Covers and protects the bottom front opening. Replace if cracked, broken, or missing.

Replaces a broken or worn refrigerator door stop that limits door travel. Prevents over-rotation damage to hinges and cabinet. Restores smooth closing.

Replacement access cover panel for refrigerators. Closes service openings and protects internal components. Needed when original is cracked or missing.

Molded drain channel that guides defrost and condensation water to the drain system. Replace if cracked, broken, or leaking to prevent water damage.

Nameplate label that attaches to your refrigerator's exterior to display model information. Replace if cracked, peeling, faded, or missing.

This is a replacement mounting screw used to secure the defrost timer assembly to the refrigerator control housing, restoring proper fastening and preventing the timer from shifting or vibrating during operation. What it does:

• Secures the defrost timer to the control housing so the timer stays in position.
• Prevents vibration or movement that can cause intermittent contact or noisy operation.
• Helps maintain reliable defrost cycle timing by keeping the timer properly aligned.
• Addresses symptoms such as a loose or missing fastener, rattling behind the control panel, or a timer that shifts when the door is opened.

• Unplug the appliance before starting work to prevent electrical shock.
• Access the control housing or timer bracket per your model's service instructions.
• Use the correct screwdriver or driver bit; do not overtighten—stop when snug to avoid stripping.
• Retain removed hardware for reference and compare screw length/threads before installing.

This is a complete refrigerator door assembly in bisque that replaces a damaged or worn door to restore appearance and proper sealing. It ships as a ready-to-install outer door panel with attached trim and mounting features. What it does:

• Replaces a cracked, dented, warped or cosmetically damaged refrigerator door
• Restores proper door fit and helps the gasket seal correctly to maintain cooling efficiency
• Replaces doors with broken handles, trim or hinge attachment points
• Improves appearance when the existing door is discolored, scratched, or otherwise worn

• Disconnect power and empty the door shelves before starting; remove food and loose items.
• Door assemblies are heavy and awkward — get a helper to support the door during removal and installation.
• Typical tools include a screwdriver or nut driver for hinge fasteners; follow manufacturer torque/fastening guidance.
• Inspect hinges, gasket and mounting hardware for wear and replace as needed; adjust door alignment after installation.

Official service data sheet with wiring diagrams and diagnostic references. Replace missing or damaged technical documentation for your appliance.