Kenmore Refrigerator 253.61794301 (25361794301, 253 61794301) Parts

Rectangular

This door stop is the replacement limiter that keeps an appliance door from over-rotating, protecting hinges and cabinet edges. It restores consistent door travel and helps the door close smoothly and securely. What it does:

• Limits how far the door opens to prevent hinge or cabinet damage
• Helps the door close in the correct position and reduces slamming
• Fits into the door/hinge assembly to provide a stable stop point
• Common symptom: door opens too far, bangs against surrounding cabinetry, or hang/align issues

• High-level replacement — remove door/hinge trim as needed per your model's instructions
• Use basic hand tools; keep fasteners separate and note orientation for reassembly
• Disconnect power if working near electrical components (applies to ovens/microwaves)

A small replacement mounting clip that secures interior trim and panels to restore proper fit and reduce rattling. Use when a broken or missing clip leaves gaps or lets panels or trim sit loose on the appliance. What it does:

• Secures trim, access panels or small plastic covers to the appliance frame
• Restores proper alignment and helps eliminate panel vibration or rattling
• Replaces cracked, worn or missing clips that allow gaps or loose parts
• Works as a simple fastener where the original clip has failed

• Always disconnect power to the appliance before beginning any repair
• Clip typically installs with a push-fit or snap-in motion; a flat tool may help remove the old clip
• Handle surrounding trim gently to avoid cracking brittle plastic
• Verify correct clip orientation before snapping into place

Made of Nylon with adhesive tape

This complete freezer door panel restores the front of the freezer door for a clean, finished look and proper closure. It replaces a dented, cracked, or cosmetically damaged outer panel so the door looks and functions like new. What it does:

• Replaces damaged or dented freezer door outer panel to restore appearance
• Provides the finished exterior surface and helps maintain proper door closure
• Useful when the original panel is cracked, warped, or cosmetically worn
• Matches the original assembly so trims and mounting points align with factory parts

• Disconnect power and empty the door before removing or installing to avoid injury
• Installation typically requires removing the freezer door and transferring handles, trims, and insulation as applicable
• Keep all screws and brackets from the original door for reassembly; alignment may be needed for a proper seal