Kenmore Refrigerator 253.67174506 (25367174506, 253 67174506) Parts

Mounting screw for refrigerators and freezers. Secures panels, brackets, and internal components. Replace when stripped, missing, or damaged.

Secures and organizes wiring harnesses in your refrigerator. Replace if broken, cracked, or wires are loose. Confirm fit with your model number.

Seals the evaporator coil cover to prevent air bypass and direct cold air over coils. Replace if worn or damaged to restore airflow and reduce frost.

Foam insulation block that fills gaps inside the refrigerator cabinet to reduce heat transfer. Replaces damaged, compressed, or missing insulation.

Plastic plug insert for refrigerator panels and structural openings. Replace if cracked, broken, or missing to maintain proper cabinet appearance.

Replace your refrigerator's handle trim piece. This decorative cover installs over the door handle. Order a new trim if yours is cracked or missing.

Refrigerator not cooling properly or running warm? This heat exchanger kit helps restore proper cooling in the sealed system. Advanced repair component.

Replaces a broken or worn refrigerator door stop that limits door travel. Prevents over-rotation damage to hinges and cabinet. Restores smooth closing.

This is a replacement mounting screw used to secure the defrost timer assembly to the refrigerator control housing, restoring proper fastening and preventing the timer from shifting or vibrating during operation. What it does:

• Secures the defrost timer to the control housing so the timer stays in position.
• Prevents vibration or movement that can cause intermittent contact or noisy operation.
• Helps maintain reliable defrost cycle timing by keeping the timer properly aligned.
• Addresses symptoms such as a loose or missing fastener, rattling behind the control panel, or a timer that shifts when the door is opened.

• Unplug the appliance before starting work to prevent electrical shock.
• Access the control housing or timer bracket per your model's service instructions.
• Use the correct screwdriver or driver bit; do not overtighten—stop when snug to avoid stripping.
• Retain removed hardware for reference and compare screw length/threads before installing.

Wiring harness for the freezer section of your refrigerator. Replace this part if the existing harness is damaged, frayed, or has corroded connections.

This freezer door restores a secure, insulated closure to the freezer compartment and improves the appliance's appearance. It replaces a damaged, dented, or warped door to help maintain proper cooling and energy efficiency. What it does:

• Replaces the freezer compartment's outer door panel to restore a tight seal and proper closure.
• Helps stop cold air loss that can cause excessive frost, longer run times, or warm/freezer temperature issues.
• Restores the exterior finish and protects internal door components from damage.
• Useful when the original door is dented, cracked, bent, or has cosmetic damage.

• One freezer door outer panel

• Disconnect power to the appliance before starting any repair.
• Support the door while removing hinge fasteners; doors are heavy and can shift unexpectedly.
• Hinge screws, trim, handle, gasket, or insulation may need to be transferred from the old door.
• After installation, check door alignment and seal; adjust hinges as needed for a proper fit.