Kenmore Refrigerator 253.7419440H (2537419440H, 253 7419440H) Parts

Bisque plug insert for refrigerator door hinge bearing hole. Replaces missing, cracked, or damaged plugs. Covers hinge pin opening for clean finish.

Secures and organizes wiring harnesses in your refrigerator. Replace if broken, cracked, or wires are loose. Confirm fit with your model number.

Foam insulation block that fills gaps inside the refrigerator cabinet to reduce heat transfer. Replaces damaged, compressed, or missing insulation.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation

Replaces your refrigerator's ice maker cover if cracked, broken, or missing. This protective cap installs on the ice maker assembly in your freezer.

Replace your refrigerator's handle trim piece. This decorative cover installs over the door handle. Order a new trim if yours is cracked or missing.

Refrigerator not cooling properly or running warm? This heat exchanger kit helps restore proper cooling in the sealed system. Advanced repair component.

Replaces a broken or worn refrigerator door stop that limits door travel. Prevents over-rotation damage to hinges and cabinet. Restores smooth closing.

Support plate for freezer interior mounting. Replaces cracked, broken, or missing support plates that compromise shelf or component stability.

Wiring harness for the freezer section of your refrigerator. Replace this part if the existing harness is damaged, frayed, or has corroded connections.

This freezer door restores a secure, insulated closure to the freezer compartment and improves the appliance's appearance. It replaces a damaged, dented, or warped door to help maintain proper cooling and energy efficiency. What it does:

• Replaces the freezer compartment's outer door panel to restore a tight seal and proper closure.
• Helps stop cold air loss that can cause excessive frost, longer run times, or warm/freezer temperature issues.
• Restores the exterior finish and protects internal door components from damage.
• Useful when the original door is dented, cracked, bent, or has cosmetic damage.

• One freezer door outer panel

• Disconnect power to the appliance before starting any repair.
• Support the door while removing hinge fasteners; doors are heavy and can shift unexpectedly.
• Hinge screws, trim, handle, gasket, or insulation may need to be transferred from the old door.
• After installation, check door alignment and seal; adjust hinges as needed for a proper fit.