Kenmore Refrigerator 253.7419440S (2537419440S, 253 7419440S) Parts

Replaces a broken or worn refrigerator door stop that limits door travel. Prevents over-rotation damage to hinges and cabinet. Restores smooth closing.

Refrigerator not cooling properly? This condenser coil assembly releases heat from the refrigerant to restore efficient cooling and keep food cold.

Replacement lever arm for refrigerator ice dispensers. Installs in the dispenser housing to activate ice release. Order if your lever is cracked or broken.

Refrigerator water inlet tube with bearing assembly. Connects water supply to ice maker or dispenser. Replace if tube is cracked, leaking, or bearing worn.

Official service data sheet with wiring diagrams and diagnostic references. Replace missing or damaged technical documentation for your appliance.

This freezer door restores a secure, insulated closure to the freezer compartment and improves the appliance's appearance. It replaces a damaged, dented, or warped door to help maintain proper cooling and energy efficiency. What it does:

• Replaces the freezer compartment's outer door panel to restore a tight seal and proper closure.
• Helps stop cold air loss that can cause excessive frost, longer run times, or warm/freezer temperature issues.
• Restores the exterior finish and protects internal door components from damage.
• Useful when the original door is dented, cracked, bent, or has cosmetic damage.

• One freezer door outer panel

• Disconnect power to the appliance before starting any repair.
• Support the door while removing hinge fasteners; doors are heavy and can shift unexpectedly.
• Hinge screws, trim, handle, gasket, or insulation may need to be transferred from the old door.
• After installation, check door alignment and seal; adjust hinges as needed for a proper fit.

A small spring-style hose clamp that secures appliance hoses and tubing to fittings to help prevent leaks and hose separation. Simple, durable clamp replacement for worn or damaged hose connections. What it does

• Holds rubber or plastic hoses firmly on barbed fittings to maintain a sealed connection.
• Helps stop water or air leaks caused by loose or deteriorated hose attachments.
• Reduces movement and rattling at hose connection points during operation.
• Commonly replaced when clamps are corroded, stretched, or no longer spring-tight.

• Disconnect power and water supply before servicing the appliance.
• Use pliers to open the spring clamp, slide into position, then release so it seats evenly around the hose.
• Inspect the hose and fitting for damage; replace hose if cracked or brittle.
• Wear eye protection and gloves; ensure clamp sits behind the hose barb for a secure seal.

Secures and protects wiring harness from strain damage. Replace if cracked, broken, or wires show wear. Verify fit with your model number listed.