Kenmore Refrigerator 253.7419940F (2537419940F, 253 7419940F) Parts

Support plate for freezer interior mounting. Replaces cracked, broken, or missing support plates that compromise shelf or component stability.

Wiring harness for the freezer section of your refrigerator. Replace this part if the existing harness is damaged, frayed, or has corroded connections.

This replacement freezer door restores a sealed, insulated closure and the exterior appearance of the freezer compartment. It installs in place of a damaged or dented door to help maintain proper cooling and prevent frost buildup. What it does:

• Replaces a cracked, dented, or damaged freezer door to restore proper closure and insulation
• Helps maintain the internal temperature by providing a tight seal when aligned correctly
• Prevents cold air loss that can lead to frost buildup and reduced efficiency
• Restores the cabinet's exterior appearance for a clean, finished look

• Disconnect power to the appliance before starting any repair
• Door assemblies are often heavy and awkward—use two people to avoid injury and prevent damage
• Keep original fasteners and gaskets unless the replacement explicitly includes them
• Check door alignment and latch/hinge operation after installation

Secures and protects wiring harness from strain damage. Replace if cracked, broken, or wires show wear. Verify fit with your model number listed.

Mounting screw for freezer and refrigerator assembly. Secures panels, shelves, or internal components. Replace if stripped, missing, or damaged.

This name plate is the replacement identification label that mounts to the appliance exterior to display model, rating and manufacturing information — making it easier to identify and service the unit. What it does:

• Provides the factory identification label with model and rating details for accurate appliance identification
• Restores legibility when the original plate is scratched, faded or missing
• Helps technicians confirm correct replacement parts and service information
• Supports resale value and safety by ensuring required labeling is visible

• One replacement name plate

• Always disconnect power and shut off gas or water supply before servicing
• Clean and dry the mounting surface before installing to ensure proper adhesion or fit
• This part replaces the visible identification plate only; the part number on the plate matches your unit before installation
• If mounting hardware or adhesive is required, use the method specified by your model's service instructions