Kenmore Refrigerator 253.74922702 (25374922702, 253 74922702) Parts

This tube connector is a small water-line fitting that joins refrigerator water and ice-maker tubing, restoring a secure path for water flow. It helps stop leaks and regain consistent water delivery to the dispenser or icemaker. What it does:

• Joins two sections of refrigerator water tubing to maintain a watertight connection
• Stops leaks at a damaged or worn tube joint
• Restores water flow to the ice maker or dispenser when a broken connector is the cause
• Compatible with rigid and soft tubing in typical refrigerator plumbing layouts

• One tube connector

• Shut off the refrigerator water supply before servicing
• Inspect tubing ends and replace damaged tubing or seals as needed
• Use proper fittings and tighten to manufacturer torque; avoid over-tightening

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation

Replaces your refrigerator's ice maker cover if cracked, broken, or missing. This protective cap installs on the ice maker assembly in your freezer.

Lower grille kickplate panel for refrigerators. Covers the base compartment below the doors. Replace if cracked, broken, discolored, or missing.

Lower hinge bracket secures the refrigerator door to the cabinet frame. Replace if cracked, bent, or corroded to restore proper door alignment.

Support plate for freezer interior mounting. Replaces cracked, broken, or missing support plates that compromise shelf or component stability.

Secures motor wiring in your refrigerator. Replace if adhesive fails or clamp breaks, causing loose wires. Confirm fit with your model number.

This water inlet tube directs incoming water from the household supply to the refrigerator's dispenser and ice-making system, restoring proper flow and preventing leaks at the appliance connection. Ideal when the original tube is cracked, clogged, or damaged. What it does:

• Carries water from the home supply line into the refrigerator's internal water system.
• Helps ensure the ice maker and dispenser receive a steady water flow.
• Commonly replaced when you see leaks at the inlet, reduced or no water flow, or visible tube damage.
• Works with the refrigerator's inlet fittings and seals to maintain a watertight connection.

• Disconnect power to the appliance and shut off the water supply before starting.
• Inspect and replace any worn seals or fittings when installing the new tube.
• Avoid sharp bends or kinks; route the tube as the OEM tubing was positioned.
• Turn the water back on and check all connections for leaks after installation.