Kenmore Refrigerator 253.77189507 (25377189507, 253 77189507) Parts

This replacement screw secures appliance components so panels, trim, or brackets stay fastened and aligned. Use it to replace lost or stripped fasteners and stop rattling, loose panels, or parts that won't sit flush. What it does

• Fastens panels, trim pieces, brackets, and small components to the appliance frame
• Replaces worn, stripped, or missing screws that cause rattling or gaps
• Restores secure mounting and alignment for doors, controls, or interior parts
• Works wherever the OEM screw 5304456677 is specified

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; do not over-torque to prevent thread or part damage
• Compare new screw to the original to ensure correct fit before installation
• Disconnect power to the appliance if working near electrical components

This replacement label provides the appliance's identification and rating information so you can restore clear model, serial, and safety marking visibility. It helps owners specifications and service details at a glance. What it does:

• Displays model, serial, and electrical rating information for the appliance
• Restores worn or missing safety and regulatory markings
• Keeps identification visible for warranty and service calls

• One replacement identification/rating label

• Clean and dry the mounting surface before applying; remove any dirt, grease, or old adhesive
• Align carefully and press firmly to ensure full adhesion; allow adhesive to set per room temperature conditions
• Do not place over vents, moving parts, or control openings
• For safety, disconnect power to the appliance before accessing internal areas to reach the original label location

Spacer component for refrigerator hold switch assembly. Replaces worn, cracked, or missing spacers. Installs between hold switch and mounting plate.

This is the factory repair parts list used to identify replacement components and part numbers for service and ordering. Keeps the appliance's parts breakdown handy for accurate repairs and parts selection. What it does:

• Shows the factory parts breakdown and reference numbers for individual components
• Helps identify which replacement part you need based on the diagram and list
• Useful for planning repairs and ordering
• Serves as a reference during disassembly and reassembly

• This is a reference document, not a replaceable mechanical or electrical component
• Keep with service records for accurate parts identification
• Handle and store flat to prevent creasing or loss of printing

The Crisper Pan Cover is an OEM part for Frigidaire refrigerators. It serves as the shelf that sits above the crisper drawers and supports various items while providing a lid to help maintain the humidity levels necessary to keep fruits and vegetables fresh longer. This cover typically is only the frame and does not include the glass.

Symptoms of a bad Crisper Pan Cover include:

• Cracks or damage to the cover that can compromise its structural integrity
• Warping or bending that affects the fit and function
• Difficulty sliding or fitting the cover properly over the crisper drawers

Causes of a bad crisper pan cover can include overloading the shelf with too much weight, impacts from dropping heavy items, or thermal stress from fluctuations in refrigerator temperatures.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Wire shelf for refrigerator freezer compartment. Replace your cracked, rusted, corroded, or missing freezer shelf. Direct fit replacement part.

This is a replacement door handle for select refrigerators. A secure, intact handle makes it easier to open and close the door and helps ensure a consistent seal.

• Provides a sturdy grip to open and close the refrigerator door
• Worn, cracked, or loose handles can feel wobbly, look damaged, or come off the door
• Restores appearance and usability of the door

• Unplug the appliance before beginning
• Handle typically attaches with concealed screws; transfer any end caps or trim from the old handle if reused
• Support the handle while tightening screws to avoid misalignment
• Do not overtighten; verify a firm, even fit