Kenmore Range 362.70251603 (36270251603, 362 70251603) Parts

Includes 12 screws.

Insulation wrap that installs around the oven cavity to reduce heat loss and dampen sound. Replace if worn, torn, compressed, or missing.

Insulation panel that installs on the back of your gas range oven cavity. Replace if damaged, deteriorated, missing, or no longer providing heat retention.

Support plate that mounts inside your gas range to provide structural reinforcement. Replace if the plate is cracked, broken, or damaged during service.

Support plate for gas range burners. Mounts beneath burner assembly to provide stable base. Replace if cracked, warped, or missing to restore proper fit.

Support bracket for gas range burners. Mounts underneath cooktop to secure burner assembly. Replace if bent, rusted, broken, or missing for proper fit.

Left-hand broiler support plate for gas ranges. Secures the broiler assembly in place. Replace if cracked, warped, or no longer holding components firmly.

Replace the door panel on your range. This decorative trim covers the exterior door surface. Order a new one if yours is cracked, scratched, or damaged.

This bottom panel replaces the damaged lower oven floor panel to restore proper support and heat protection for cookware and internal components. It helps stop rattling, sagging, and hot spots that can affect bake performance. What it does:

• Provides a stable, heat-resistant surface at the bottom of the oven cavity
• Protects underlying components from spills, drips and direct heat
• Prevents sagging or warped oven floor that can cause cookware instability
• Can reduce rattling or vibration caused by a loose or damaged panel

• Disconnect power to the range before beginning any work.
• Remove oven racks and allow the oven to cool completely.
• Handle edges carefully; use gloves to avoid cuts and protect the finish.
• Installation typically requires removing access screws and aligning the panel into the oven floor supports.

Secures and supports internal components in your range. Replace this brace if it's bent, broken, or missing to ensure proper alignment and stability.

Secures and routes wiring inside your range to prevent chafing or contact. Replace if cracked, broken, or missing to keep wires safely clipped to chassis.