Kenmore Range 362.71675890 (36271675890, 362 71675890) Parts

If your gas range burners won't ignite or click constantly, this spark module generates the high-voltage pulses needed to light the burners reliably.

Size: 10-32 GXTT FLP.595 S

Replacement orifice spud that threads into the cooktop surface burner holder to meter gas flow. Needed when converting fuel types or replacing worn parts.

White plastic end cap for the right side of your range. Replaces old, yellowed, cracked, or broken trim pieces. Restores a clean appearance.

White plastic end cap that installs on the left side of your range control panel. Replaces cracked, yellowed, broken, or missing trim pieces.

Replacement mounting screw secures panels, brackets, and trim on ranges and cooktops. Install to replace missing, stripped, or rusted fasteners.

Secures components to your appliance chassis for a rattle-free fit. Replace missing, stripped, or corroded screws to keep panels and brackets aligned.

Factory screw secures brackets, panels, trim, or burner components on ranges, cooktops, and wall ovens. Replaces missing, stripped, or corroded fasteners.

Secures the thermostat sensing bulb to the oven cavity wall for accurate temperature control. Replace if missing or damaged to prevent sagging bulb.

Spacer that fits between mating parts in your range or oven to maintain proper clearance and alignment. Replace if worn, missing, or damaged to prevent rubbing.

Includes 12 screws.

This tube routes water from the refrigerator's water valve to the dispenser or ice system, restoring proper water flow and stopping leaks when a cracked or clogged supply tube is the issue. Easy direct replacement for affected lines. What it does

• Carries water from the valve to the dispenser or ice maker so the appliance can fill and dispense properly.
• Commonly replaced when you see leaks at fittings, a puddle under the fridge, or a visibly cracked or split tube.
• Can restore normal water flow when the line is pinched, kinked, or partially obstructed.
• Works with factory fittings and clamps used on the valve-to-ice maker/dispenser connection.

• Turn off the refrigerator's water supply and unplug the appliance before starting; drain remaining water from the line.
• Inspect fittings for damage; loosen or remove existing clamps/fittings to swap the tube, then secure new tube and clamps to prevent leaks.
• After installation, restore water and power, check all connections for leaks, and run the dispenser/ice maker briefly to confirm proper flow.

Oven light switch.

Package of 12

Size: 8 - 32 inch.

White plastic end cover for the right side of your range. Replaces cracked, broken, or discolored endcaps to restore a finished appearance.