Kenmore Range 362.71675891 (36271675891, 362 71675891) Parts

Genuine Ge part

Retainer Clip

By: Ge

Part Number: WB2X1082

Clip for door hinge.

Do-It-Yourself Stories from Customers like You Broken door hinge. Shari W. • Evansville , IN • February 07, 2018

By replacing the hinge. Read more

Genuine Ge part

This handle cap is a replacement end cover that restores the clean finished look and protects the handle mounting on compatible refrigerators. It keeps the handle edges covered and helps prevent snags and cosmetic damage. What it does:

Covers and protects the exposed end of a refrigerator door handle for a finished appearance
Conceals handle mounting hardware and reduces dirt build-up around the handle area
Helps prevent clothing snags and minimizes wear at the handle end
Matches light white finish to blend with white appliance trim

What's included:

One handle cap

Install notes:

Remove original cap by following the appliance manual; some models use hidden clips or a retaining screw
Keep existing mounting hardware — this cap is a cosmetic cover and typically uses factory fasteners
Avoid over-tightening clips or screws to prevent cracking the cap

Do-It-Yourself Stories from Customers like You End caps for oven door had broken and kept falling out Barbara L. • Roanoke , VA • January 05, 2019

Somewhat difficult to slide back on because pieces of the old tabs were stuck in the crevace, but once I realized and fished them out the next challenge was finally figuring out part went inside the crevace and part (a tab) went outside on the back of the handle. If you bend over and look up underneath it is easy to see how it goes, but apparently over the years the handle had gotten just out of shape enough that the caps did not readily slide on. Be careful you don't snap a tab or post off. ... Read more

Genuine Ge part

Support Rivet

By: Ge

Part Number: WB10K13

Right hand side

Genuine Ge part

Spring Door

5.0 (1)

By: Ge

Part Number: WB9K1

Do-It-Yourself Stories from Customers like You Two springs on oven door were worn out William T. • Washington , DC • February 06, 2019

Replaced the oven door springs. Read more

Genuine Ge part

End Cap Screw (White)

5.0 (1)

By: Ge

Part Number: WB01K10004

Color: White. Mounting screw for end caps.

Do-It-Yourself Stories from Customers like You Needed to replace two screws that were rusted Russell S. • Jefferson , GA • May 22, 2020

Replaced screws, would have liked to replace discolored plastic end plates but not for $35 to $40 dollars per end cap. Read more

Genuine Ge part

Knob - Top Bur

By: Ge

Part Number: WB03K10013

Genuine Ge part

Panel, Oven Bottom

5.0 (6)

By: Ge

Part Number: WB53K35

Do-It-Yourself Stories from Customers like You The panel on the oven bottom was pitted and needed to be replaced Kenneth W. • Buffalo , MN • November 29, 2014

Simple as can be. Took 2 screws out, pulled out the old panel, and put the new one in. Done in five mintures Read more

Genuine Ge part

Range Top Support Rod

5.0 (3)

By: Ge

Part Number: WB6K8

Do-It-Yourself Stories from Customers like You I replaced the cooktop in my range. Carol Z. • Bronx , NY • November 02, 2020

My 12 year-old cooktop was rusted through in a couple of key places, but the rest of my range was in terrific shape, so I decided to order a replacement cooktop. The perfect part arrived quickly. When I took a closer look at the few connecting parts I thought I was going to pirate off the old cooktop, I saw some were rusty, particularly the two Guide Slides and one screw. I needed to buy a set of star drivers, too, as a #10 was needed. I put a little WD40 on the parts I had to remove when I... Read more