Kenmore Range 362.72324100 (36272324100, 362 72324100) Parts

Left hand side

This trim vent door is the finished vent trim piece that mounts to the refrigerator/freezer door opening to direct airflow and complete the exterior look. It restores proper venting appearance and helps maintain consistent airflow through the door cavity. What it does:

• Replaces damaged or cracked vent trim on the refrigerator/freezer door
• Directs internal airflow through the door vent for proper circulation
• Restores a clean, finished appearance to the door exterior
• Helps prevent debris from entering the door vent area

• Remove power to the appliance before starting work to avoid electrical or injury risk
• This part typically snaps or screws into place from the door face or interior; follow your model's service manual for exact steps
• Keep all fasteners and clips; replace any broken clips for a secure fit

This right-hand end plate is a direct-replacement body panel that restores proper support and alignment to the appliance's exterior components. It helps maintain a secure fit and appearance after damage or wear. What it does:

• Replaces a bent, cracked, or corroded right-side end plate to restore panel alignment
• Provides mounting/support for adjacent trim and components to prevent gaps or sagging
• Stops rattling or vibration caused by a loose or damaged end plate
• Helps maintain a finished exterior look and proper sealing where panels meet

• One right-hand end plate

• Disconnect power (and water, if applicable) before beginning any repair
• Use appropriate hand tools; avoid overtightening fasteners to prevent panel distortion
• Handle edges carefully — panels and sheet metal can be sharp
• Test fit and align panels before fully tightening all screws

A replacement vent brace that secures the appliance vent assembly and helps keep vent components aligned for steady airflow and quiet operation. Restores proper support to a loose or sagging vent assembly. What it does:

• Supports and stabilizes the vent/duct assembly so it stays aligned during use
• Reduces vibration and rattling caused by a loose vent bracket
• Helps maintain proper airflow by keeping vent components in the correct position
• Fits where the original vent brace mounts to the appliance frame

• Disconnect power (and gas, if applicable) before servicing the appliance
• Remove the appropriate access panels to reach the vent area; keep fasteners for reassembly
• Verify bracket orientation and screw locations match the original before tightening

Right hand side

Left hand side

Color: Biscuit