Kenmore Range 362.72324101 (36272324101, 362 72324101) Parts

Mounting bracket secures oven components inside your range. Replace if bracket is bent, cracked, broken, or missing to restore proper structural support.

Replace worn felt pad gasket to prevent heat loss and reduce noise in your range. Cushions components and ensures proper sealing. Confirm fit with model number.

This right-side refrigerator drain/collector pan catches and directs defrost and condensation water into the drain system to prevent pooling and help maintain proper appliance operation. Designed as a direct replacement using the OEM mounting points. What it does:

• Collects defrost and condensation water from the evaporator area
• Channels water to the drain line to prevent leaks and puddles beneath the fridge
• Supports nearby components and fits into the factory pan cavity
• Commonly replaced when cracked, warped, or leaking

• Disconnect power to the appliance before beginning work
• Remove the toe kick and any shelving or components blocking access to the pan
• Handle carefully to avoid damaging the drain connection and adjacent parts

Right hand side

Left hand side

This trim vent door is the finished vent trim piece that mounts to the refrigerator/freezer door opening to direct airflow and complete the exterior look. It restores proper venting appearance and helps maintain consistent airflow through the door cavity. What it does:

• Replaces damaged or cracked vent trim on the refrigerator/freezer door
• Directs internal airflow through the door vent for proper circulation
• Restores a clean, finished appearance to the door exterior
• Helps prevent debris from entering the door vent area

• Remove power to the appliance before starting work to avoid electrical or injury risk
• This part typically snaps or screws into place from the door face or interior; follow your model's service manual for exact steps
• Keep all fasteners and clips; replace any broken clips for a secure fit

Right-hand end plate for electric ranges. Replaces cracked, bent, or corroded exterior panel. Restores proper support and alignment to side components.

Left side end plate for electric ranges. Replaces cracked, broken, or missing end panels that provide structural support and finished appearance.

A replacement vent brace that secures the appliance vent assembly and helps keep vent components aligned for steady airflow and quiet operation. Restores proper support to a loose or sagging vent assembly. What it does:

• Supports and stabilizes the vent/duct assembly so it stays aligned during use
• Reduces vibration and rattling caused by a loose vent bracket
• Helps maintain proper airflow by keeping vent components in the correct position
• Fits where the original vent brace mounts to the appliance frame

• Disconnect power (and gas, if applicable) before servicing the appliance
• Remove the appropriate access panels to reach the vent area; keep fasteners for reassembly
• Verify bracket orientation and screw locations match the original before tightening

Left hand side

Left side panel for gas range ovens. Replaces cracked, damaged, or missing exterior side panels. Structural component for oven cabinet assembly.