Kenmore Range 362.72429201 (36272429201, 362 72429201) Parts

This right-side end cap replaces a worn or broken trim piece to restore a clean finish and secure fit on the appliance. It helps maintain proper alignment of the adjacent trim or shelving and improves appearance. What it does:

• Covers and protects the outer end of a trim piece or shelf; keeps edges finished and snag-free
• Secures the trim/shelf edge to prevent movement or gaps
• Common replacement when the original is cracked, chipped, warped, or missing
• Helps prevent food snags and improves overall cabinet/compartment appearance

• Typically snaps or slides into place; some models may use a single fastener — inspect the mounting area before installation
• No electrical disconnect usually required for trim parts, but remove nearby items and work carefully to avoid damage
• Wear gloves to avoid cuts from sharp edges and to protect the finish
• If the cap doesn't seat easily, check for broken retention tabs before forcing

This canal bracket secures the oven backguard assembly, keeping the backguard and adjacent panels aligned for stable operation and proper airflow. It's a direct-fit replacement when the original bracket is bent, cracked, or missing. What it does:

• Anchors the backguard/canal area to the range chassis to prevent movement and vibration.
• Restores proper panel alignment and helps eliminate rattling or gaps behind the control panel.
• Maintains correct spacing for airflow and component clearance in the backguard area.
• Helps ensure control and wiring assemblies remain supported and positioned.

• Disconnect power to the appliance before beginning any service.
• Handle sharp edges and sheet metal carefully; wear gloves and eye protection.
• Remove backguard or access panels per the range's service instructions to reach the bracket mounting points.
• Verify bracket orientation and fastener type match the original; use existing hardware unless replacements are specified.