Kenmore Range 362.73422201 (36273422201, 362 73422201) Parts

Left-hand broiler support plate for gas ranges. Secures the broiler assembly in place. Replace if cracked, warped, or no longer holding components firmly.

This bottom panel replaces the damaged lower oven floor panel to restore proper support and heat protection for cookware and internal components. It helps stop rattling, sagging, and hot spots that can affect bake performance. What it does:

• Provides a stable, heat-resistant surface at the bottom of the oven cavity
• Protects underlying components from spills, drips and direct heat
• Prevents sagging or warped oven floor that can cause cookware instability
• Can reduce rattling or vibration caused by a loose or damaged panel

• Disconnect power to the range before beginning any work.
• Remove oven racks and allow the oven to cool completely.
• Handle edges carefully; use gloves to avoid cuts and protect the finish.
• Installation typically requires removing access screws and aligning the panel into the oven floor supports.

Flat guide for range top assembly. Supports and aligns cooktop components during installation. Replace if cracked, bent, or missing for proper fit.

Insulation panel that installs at the top of your range door to reduce heat transfer and dampen sound. Replace if cracked, deteriorated, or missing.

This canal bracket secures the oven backguard assembly, keeping the backguard and adjacent panels aligned for stable operation and proper airflow. It's a direct-fit replacement when the original bracket is bent, cracked, or missing. What it does:

• Anchors the backguard/canal area to the range chassis to prevent movement and vibration.
• Restores proper panel alignment and helps eliminate rattling or gaps behind the control panel.
• Maintains correct spacing for airflow and component clearance in the backguard area.
• Helps ensure control and wiring assemblies remain supported and positioned.

• Disconnect power to the appliance before beginning any service.
• Handle sharp edges and sheet metal carefully; wear gloves and eye protection.
• Remove backguard or access panels per the range's service instructions to reach the bracket mounting points.
• Verify bracket orientation and fastener type match the original; use existing hardware unless replacements are specified.