Kenmore Range 362.73424201 (36273424201, 362 73424201) Parts

Replacement broiler pin for gas ranges. This metal pin secures the broiler drawer in place. Order a new pin if your original is bent, broken, or missing.

Replace your gas range's broken or worn oven door hinge. This hinge bracket secures the door for smooth opening and closing. Ideal for cracked hinges.

This harness module connects and routes electrical signals between components to restore reliable circuit connections and control communication. It replaces a damaged or worn module to help appliances power and operate correctly. What it does:

• Routes power and signal connections between internal components to ensure consistent electrical continuity
• Replaces broken, frayed, or corroded wiring that can cause intermittent operation or loss of function
• Helps resolve symptoms such as lights or controls not responding, intermittent cycles, or non-start conditions when traced to the harness
• Maintains correct connector fit and pin alignment for secure component mating

• One harness module as shown

• Disconnect power before servicing to avoid shock or damage
• Inspect connectors and mating components for damage or corrosion before installation
• Secure harness away from sharp edges and moving parts; follow OEM routing and fastening points

Speed nut for electric and gas ranges. Secures panels and components inside your range. Replace if stripped, missing, or no longer holding parts firmly.

Includes 12 screws.

This is a bisque-colored rocker switch used on ranges and ovens. It controls the on/off function of a specific burner or feature on the cooktop or oven panel. Replace this switch if it feels loose, won't stay in position, or fails to activate the associated heating element when toggled.

Insulation that installs on the side of your range door to reduce heat transfer and dampen sound. Replace if worn, torn, compressed, or missing.

Support plate for gas range burners. Mounts beneath burner assembly to provide stable base. Replace if cracked, warped, or missing to restore proper fit.

Support bracket for gas range burners. Mounts underneath cooktop to secure burner assembly. Replace if bent, rusted, broken, or missing for proper fit.

Left-hand broiler support plate for gas ranges. Secures the broiler assembly in place. Replace if cracked, warped, or no longer holding components firmly.

This bottom panel replaces the damaged lower oven floor panel to restore proper support and heat protection for cookware and internal components. It helps stop rattling, sagging, and hot spots that can affect bake performance. What it does:

• Provides a stable, heat-resistant surface at the bottom of the oven cavity
• Protects underlying components from spills, drips and direct heat
• Prevents sagging or warped oven floor that can cause cookware instability
• Can reduce rattling or vibration caused by a loose or damaged panel

• Disconnect power to the range before beginning any work.
• Remove oven racks and allow the oven to cool completely.
• Handle edges carefully; use gloves to avoid cuts and protect the finish.
• Installation typically requires removing access screws and aligning the panel into the oven floor supports.

This mounting screw secures an appliance end cap or trim piece, keeping covers and brackets fastened for safe, stable operation. It's a direct-fit replacement used when the original screw is lost, stripped, or damaged. What it does:

• Secures the end cap or trim to the appliance frame to prevent gaps and movement
• Stops rattling or vibration caused by a missing or worn screw
• Holds covers in place to protect internal components from debris
• Restores proper fit and alignment of the end cap/trim

• Disconnect power before servicing the appliance
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and tighten until snug—do not overtighten
• Replace damaged screws or threaded inserts to ensure a secure fit