Kenmore Range 362.73429202 (36273429202, 362 73429202) Parts

This bottom panel replaces the damaged lower oven floor panel to restore proper support and heat protection for cookware and internal components. It helps stop rattling, sagging, and hot spots that can affect bake performance. What it does:

• Provides a stable, heat-resistant surface at the bottom of the oven cavity
• Protects underlying components from spills, drips and direct heat
• Prevents sagging or warped oven floor that can cause cookware instability
• Can reduce rattling or vibration caused by a loose or damaged panel

• Disconnect power to the range before beginning any work.
• Remove oven racks and allow the oven to cool completely.
• Handle edges carefully; use gloves to avoid cuts and protect the finish.
• Installation typically requires removing access screws and aligning the panel into the oven floor supports.

This mounting screw secures an appliance end cap or trim piece, keeping covers and brackets fastened for safe, stable operation. It's a direct-fit replacement used when the original screw is lost, stripped, or damaged. What it does:

• Secures the end cap or trim to the appliance frame to prevent gaps and movement
• Stops rattling or vibration caused by a missing or worn screw
• Holds covers in place to protect internal components from debris
• Restores proper fit and alignment of the end cap/trim

• Disconnect power before servicing the appliance
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and tighten until snug—do not overtighten
• Replace damaged screws or threaded inserts to ensure a secure fit

This right-side end cap replaces a worn or broken trim piece to restore a clean finish and secure fit on the appliance. It helps maintain proper alignment of the adjacent trim or shelving and improves appearance. What it does:

• Covers and protects the outer end of a trim piece or shelf; keeps edges finished and snag-free
• Secures the trim/shelf edge to prevent movement or gaps
• Common replacement when the original is cracked, chipped, warped, or missing
• Helps prevent food snags and improves overall cabinet/compartment appearance

• Typically snaps or slides into place; some models may use a single fastener — inspect the mounting area before installation
• No electrical disconnect usually required for trim parts, but remove nearby items and work carefully to avoid damage
• Wear gloves to avoid cuts from sharp edges and to protect the finish
• If the cap doesn't seat easily, check for broken retention tabs before forcing