Kenmore Range 362.75205892 (36275205892, 362 75205892) Parts
Genuine Ge part
By: Ge
Part Number: WB2K11
Genuine Ge part
By: Ge
Part Number: WB2X1082
Clip for door hinge.
Do-It-Yourself Stories from Customers like You
Broken door hinge. Shari W. • Evansville , IN • February 07, 2018
By replacing the hinge.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB7K5339
This handle cap is a replacement end cover that restores the clean finished look and protects the handle mounting on compatible refrigerators. It keeps the handle edges covered and helps prevent snags and cosmetic damage. What it does:
- Covers and protects the exposed end of a refrigerator door handle for a finished appearance
- Conceals handle mounting hardware and reduces dirt build-up around the handle area
- Helps prevent clothing snags and minimizes wear at the handle end
- Matches light white finish to blend with white appliance trim
What's included:
Install notes:
- Remove original cap by following the appliance manual; some models use hidden clips or a retaining screw
- Keep existing mounting hardware — this cap is a cosmetic cover and typically uses factory fasteners
- Avoid over-tightening clips or screws to prevent cracking the cap
Do-It-Yourself Stories from Customers like You
End caps for oven door had broken and kept falling out Barbara L. • Roanoke , VA • January 05, 2019
Somewhat difficult to slide back on because pieces of the old tabs were stuck in the crevace, but once I realized and fished them out the next challenge was finally figuring out part went inside the crevace and part (a tab) went outside on the back of the handle. If you bend over and look up underneath it is easy to see how it goes, but apparently over the years the handle had gotten just out of shape enough that the caps did not readily slide on. Be careful you don't snap a tab or post off. ...
Read more
More
Genuine Ge part
By: Ge
Part Number: WB10K13
Genuine Ge part
By: Ge
Part Number: WB21K20
Do-It-Yourself Stories from Customers like You
Bab gas valve Robert S. • East Northport , NY • November 21, 2016
Ordered replacement valve from ApplianceParts.com and reapired it myself.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB24K10003
This valve switch includes a gray hub and sparks at the 7 o'clock position. For the orange hub valve switch order WB24K10002.
More
Genuine Ge part
By: Ge
Part Number: WB9K1
Do-It-Yourself Stories from Customers like You
Two springs on oven door were worn out William T. • Washington , DC • February 06, 2019
Replaced the oven door springs.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB01K10004
Color: White. Mounting screw for end caps.
Do-It-Yourself Stories from Customers like You
Needed to replace two screws that were rusted Russell S. • Jefferson , GA • May 22, 2020
Replaced screws, would have liked to replace discolored plastic end plates but not for $35 to $40 dollars per end cap.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB03K10013
Genuine Ge part
By: Ge
Part Number: WB53K35
Do-It-Yourself Stories from Customers like You
The panel on the oven bottom was pitted and needed to be replaced Kenneth W. • Buffalo , MN • November 29, 2014
Simple as can be. Took 2 screws out, pulled out the old panel, and put the new one in. Done in five mintures
Read more
More
Genuine Ge part
By: Ge
Part Number: WB02K10007
Genuine Ge part
By: Ge
Part Number: WB02K10008
Do-It-Yourself Stories from Customers like You
The burner broke while i was taking it apart for cleaning Jose H. • Brownsville , TX • June 27, 2015
It was really tight. Had to undo the gas line from the control valve. Had to put the burner on a vise to remove the gas line from it.
Read more
More
Genuine Ge part
By: Ge
Part Number: WB03K10011
Genuine Ge part
By: Ge
Part Number: WB10K14
Genuine Ge part
By: Ge
Part Number: WB13K10003
Electrode
Do-It-Yourself Stories from Customers like You
Ignitor discolored and hard to lite burner had to start using lighter William S. • Bel Air , MD • November 28, 2016
Watch U-tube video but wrong for my stove
Disconnected burner from top which I did not have to do
All I had to do was pull ignitor straight up (wire would come with it and disconnect wire from ceramic then push back into place
Because I disconnected via video insturction turned a five minute job into a 30 minute job
Burner ignites now
Wife happy (best)
Read more
More
Genuine Ge part
By: Ge
Part Number: WB15K17