Kenmore Range 362.75206891 (36275206891, 362 75206891) Parts

Genuine Ge part

Range Oven Door Hinge Pin

By: Ge

Part Number: WB14K5

Pivot pin that connects the oven door hinge to its mounting bracket. Replace if worn, broken, or missing to restore smooth door operation and alignment.

Genuine Ge part

This retainer secures the oven door hinges in place and is located at the bottom corners of the oven door frame. Replace if the oven door sags, won't stay closed properly, or if the hinges appear loose or misaligned.

Do-It-Yourself Stories from Customers like You Broken door hinge. Shari W. • Evansville , IN • February 07, 2018

By replacing the hinge. Read more

Genuine Ge part

Panel, Oven Bottom

5.0 (6)

By: Ge

Part Number: WB53K35

Do-It-Yourself Stories from Customers like You The panel on the oven bottom was pitted and needed to be replaced Kenneth W. • Buffalo , MN • November 29, 2014

Simple as can be. Took 2 screws out, pulled out the old panel, and put the new one in. Done in five mintures Read more

Genuine Ge part

Burner Bracket

By: Ge

Part Number: WB02K10007

Small

Genuine Ge part

Bracket-Burner Large

5.0 (1)

By: Ge

Part Number: WB02K10008

Do-It-Yourself Stories from Customers like You The burner broke while i was taking it apart for cleaning Jose H. • Brownsville , TX • June 27, 2015

It was really tight. Had to undo the gas line from the control valve. Had to put the burner on a vise to remove the gas line from it. Read more

Genuine Ge part

Knob - Surface

By: Ge

Part Number: WB03K10021

Genuine Ge part

Support Rivet

By: Ge

Part Number: WB10K14

Left hand side

Genuine Ge part

Top Burner Igniter

4.0 (1)

By: Ge

Part Number: WB13K10003

Electrode

Do-It-Yourself Stories from Customers like You Ignitor discolored and hard to lite burner had to start using lighter William S. • Bel Air , MD • November 28, 2016

Watch U-tube video but wrong for my stove Disconnected burner from top which I did not have to do All I had to do was pull ignitor straight up (wire would come with it and disconnect wire from ceramic then push back into place Because I disconnected via video insturction turned a five minute job into a 30 minute job Burner ignites now Wife happy (best) Read more