Kenmore Range 362.7526891 (3627526891, 362 7526891) Parts

Insulation pad that lines the oven door to retain heat and reduce exterior temperature. Replace if torn, compressed, or missing for proper efficiency.

Endcap for range storage drawer. Installs at drawer end to provide finished edge and structural support. Replace if cracked, broken, or missing.

This console span is a metal support bracket that stabilizes the appliance control console, helping keep the control panel aligned and reducing flex or vibration for reliable button and switch operation. What it does:

• Supports and positions the console/control panel to prevent sagging or misalignment
• Reduces vibration and rattling that can affect button feel or electrical contacts
• Restores proper gap and fit between the control assembly and cabinet
• Helps maintain stable mounting for switches, displays, and user controls

• One console span support bracket

• Always disconnect power before attempting any repairs to avoid shock or injury
• Remove the control panel or console trim per service instructions to access the bracket
• Use basic hand tools; align bracket and secure fasteners without over-tightening

Positions the gas orifice for proper burner alignment and gas flow. Replace if bent, corroded, or damaged to restore secure orifice placement and safe burner operation.

A replacement vent brace that secures the appliance vent assembly and helps keep vent components aligned for steady airflow and quiet operation. Restores proper support to a loose or sagging vent assembly. What it does:

• Supports and stabilizes the vent/duct assembly so it stays aligned during use
• Reduces vibration and rattling caused by a loose vent bracket
• Helps maintain proper airflow by keeping vent components in the correct position
• Fits where the original vent brace mounts to the appliance frame

• Disconnect power (and gas, if applicable) before servicing the appliance
• Remove the appropriate access panels to reach the vent area; keep fasteners for reassembly
• Verify bracket orientation and screw locations match the original before tightening