Kenmore Range 362.75329102 (36275329102, 362 75329102) Parts

Genuine Ge part

Knob - Top Bur

By: Ge

Part Number: WB03K10010

Do-It-Yourself Stories from Customers like You This range had deteriorated burner drip pans and the wrong burner control knobs Jim H. • Mansfield Center , CT • July 01, 2016

Replacement was easy and only took a few minutes. They were a perfect match. Parts were well packaged and received in a few days. Will definitely buy from this company again. Read more

Genuine Ge part

Broil Burner

5.0 (2)

By: Ge

Part Number: WB16K10004

Do-It-Yourself Stories from Customers like You Broiler taking too long to light and burner metal burning through Paul H. • Bixby , OK • October 31, 2018

Replaced the Broil Burner and Oven Igniter. Removed the door (lifts out easily). Moved out oven to access electrical socket and gas line. Unplugged electricity. Shut off gas. Disconnected gas line. Moved out oven to access back panel. Disconnected Igniter clip. Removed the small access plate. Unscrewed holding screws from broil burner and removed the old Burner and Igniter. Put the new burner and Igniter together and reversed the process. So far so good. Was a $70 repair or a $1000 new... Read more

Genuine Ge part

Oven Door Hinge Retainer

5.0 (2)

By: Ge

Part Number: WB2X1082

This retainer secures the oven door hinges in place and is located at the bottom corners of the oven door frame. Replace if the oven door sags, won't stay closed properly, or if the hinges appear loose or misaligned.

Do-It-Yourself Stories from Customers like You Broken door hinge. Shari W. • Evansville , IN • February 07, 2018

By replacing the hinge. Read more

Genuine Ge part

End Cap Screw (White)

5.0 (1)

By: Ge

Part Number: WB01K10004

Color: White. Mounting screw for end caps.

Do-It-Yourself Stories from Customers like You Needed to replace two screws that were rusted Russell S. • Jefferson , GA • May 22, 2020

Replaced screws, would have liked to replace discolored plastic end plates but not for $35 to $40 dollars per end cap. Read more

Genuine Ge part

Range Oven Door Hinge Pin

By: Ge

Part Number: WB14K5

Pivot pin that connects the oven door hinge to its mounting bracket. Replace if worn, broken, or missing to restore smooth door operation and alignment.

Genuine Ge part

Switch, Rocker

5.0 (1)

By: Ge

Part Number: WB24X415

Color: Black

Do-It-Yourself Stories from Customers like You Old worn parts Billy S. • Newport News , VA • February 26, 2016

Easy removal of worn parts and easy installation of new parts. Read more

Genuine Ge part

End Cap Lt (Blk)

By: Ge

Part Number: WB07K10004

Genuine Ge part

Support Rivet

By: Ge

Part Number: WB10K14

Left hand side

Genuine Ge part

Top Burner Igniter

4.0 (1)

By: Ge

Part Number: WB13K10003

Electrode

Do-It-Yourself Stories from Customers like You Ignitor discolored and hard to lite burner had to start using lighter William S. • Bel Air , MD • November 28, 2016

Watch U-tube video but wrong for my stove Disconnected burner from top which I did not have to do All I had to do was pull ignitor straight up (wire would come with it and disconnect wire from ceramic then push back into place Because I disconnected via video insturction turned a five minute job into a 30 minute job Burner ignites now Wife happy (best) Read more

Genuine Ge part

Screw

By: Ge

Part Number: WB1X5716

Genuine Ge part

Switch Latch

By: Ge

Part Number: WB24K10010

Genuine Ge part

Control

5.0 (2)

By: Ge

Part Number: WB27K10141

Do-It-Yourself Stories from Customers like You Sensor Daniel P. • Riverton , WY • February 14, 2015

ORDERD sensor PART AND IT CAME VERY FAST,I ORDERED A CONTROL BOARD ALSO AND IT CAME FAST AND IN BUBBLE RAP. VERY GOOD SERVICE A+ Read more

Genuine Ge part

Orifice Spud

5.0 (4)

By: Ge

Part Number: WB28K10022

Natural gas. Med 1.50mm

Do-It-Yourself Stories from Customers like You Propane to natural gas conversion on range and dryer Vincent P. • Howell , NJ • October 09, 2014

Confirmed parts needed through online chat with tech and followed video instructions for dryer conversion. Found a video online for range conversion. Replaced orifices for stove top and adjusted oven burner orifices and air shutters and inverted pin in pressure regulator to natural gas position. All went well with no problems, about an hour and a half to gather tools and complete both jobs. Probably could be done faster but I was taking my time. Read more