Kenmore Range 362.75471690 (36275471690, 362 75471690) Parts

Right hand side

Wire clip secures electrical connections to heating elements in ranges. Replace if worn, cracked, or loose to restore proper contact. Verify fit with model.

Speed nut for electric and gas ranges. Secures panels and components inside your range. Replace if stripped, missing, or no longer holding parts firmly.

Includes 12 screws.

Secures wiring harnesses in your range. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number before ordering.

Support bracket for gas ranges. Secures internal components in place. Replace if bracket is bent, cracked, broken, or missing to restore proper fit.

Top support plate for gas ranges. Mounts beneath the cooktop surface to provide structural reinforcement. Replace if cracked, bent, or damaged.

Broil shield for gas ranges. Mounts inside the oven cavity to protect components from direct heat. Replace if cracked, warped, or damaged.

Rear housing panel that covers the back of your range. Replace this cover if it's cracked, dented, rusted, or missing to restore your appliance's appearance.

Replace a cracked, warped, or missing heat deflector shield on your range. This protective guard installs near heating elements to direct heat properly.

Secures and supports internal components in your range. Replace this brace if it's bent, broken, or missing to ensure proper alignment and stability.

Bottom guard for gas ranges. Installs at the base to protect internal components. Replace if cracked, damaged, or missing to maintain appliance integrity.

Protective bottom guard for your range. Shields internal components from debris and damage. Replace if cracked, bent, or missing for proper protection.

Replace your damaged or missing range burner box cover. This protective housing installs over the burner assembly. Ideal for cracked or broken covers.

Endcap for range storage drawer. Installs at drawer end to provide finished edge and structural support. Replace if cracked, broken, or missing.

This under-cabinet installation support is a replacement mounting bracket used to secure an appliance to the cabinetry for stable, safe operation. It restores proper support and helps stop wobble or misalignment during use. What it does:

• Provides a secure mounting point to hold the appliance against the cabinet
• Helps prevent shifting, vibration, and uneven operation caused by loose or damaged hardware
• Restores proper alignment for doors and controls affected by a loose mount
• Used when original installation supports are missing, bent, or broken

• Follow the appliance manufacturer's installation instructions and recommended fasteners
• Turn off power to the appliance before attempting any installation or adjustment
• May require basic hand tools; check fit and orientation before final tightening