Kenmore Range 362.75581891 (36275581891, 362 75581891) Parts

Inner

This tech sheet is the manufacturer service guide that helps technicians and knowledgeable DIYers identify controls, wiring and specifications for service or repair tasks. It clarifies component locations and diagnostic points for accurate troubleshooting. What it does:

• Summarizes key specifications and electrical wiring diagrams used during service
• Identifies control locations and component references for faster diagnostics
• Supports proper troubleshooting by listing common failure points and test points
• Helps part orientation and connector locations during replacement

• Review the sheet fully before starting repairs to plan safe disconnection and tests
• Always disconnect power and follow lockout/tagout procedures before servicing
• Use the information as a supplement to official service manuals and safety guidelines

Color: White.

Right hand side

Left hand side

This right-hand end plate is a direct-replacement body panel that restores proper support and alignment to the appliance's exterior components. It helps maintain a secure fit and appearance after damage or wear. What it does:

• Replaces a bent, cracked, or corroded right-side end plate to restore panel alignment
• Provides mounting/support for adjacent trim and components to prevent gaps or sagging
• Stops rattling or vibration caused by a loose or damaged end plate
• Helps maintain a finished exterior look and proper sealing where panels meet

• One right-hand end plate

• Disconnect power (and water, if applicable) before beginning any repair
• Use appropriate hand tools; avoid overtightening fasteners to prevent panel distortion
• Handle edges carefully — panels and sheet metal can be sharp
• Test fit and align panels before fully tightening all screws

A replacement vent brace that secures the appliance vent assembly and helps keep vent components aligned for steady airflow and quiet operation. Restores proper support to a loose or sagging vent assembly. What it does:

• Supports and stabilizes the vent/duct assembly so it stays aligned during use
• Reduces vibration and rattling caused by a loose vent bracket
• Helps maintain proper airflow by keeping vent components in the correct position
• Fits where the original vent brace mounts to the appliance frame

• Disconnect power (and gas, if applicable) before servicing the appliance
• Remove the appropriate access panels to reach the vent area; keep fasteners for reassembly
• Verify bracket orientation and screw locations match the original before tightening