Kenmore Range 362.75585892 (36275585892, 362 75585892) Parts

Broil shield for gas ranges. Mounts inside the oven cavity to protect components from direct heat. Replace if cracked, warped, or damaged.

Replace the upper back cover on your gas range. This housing panel protects internal components and completes the exterior finish. Order now if cracked or missing.

Rear housing panel that covers the back of your range. Replace this cover if it's cracked, dented, rusted, or missing to restore your appliance's appearance.

Replace a cracked, warped, or missing heat deflector shield on your range. This protective guard installs near heating elements to direct heat properly.

Oven vent assembly for gas ranges. Mounts inside the oven cavity to channel heat and steam. Replace if cracked, damaged, or missing for proper ventilation.

Door liner weld assembly for electric ranges. Replaces cracked, damaged, or broken door liner frames. Structural component that secures inner door panel.

Secures and supports internal components in your range. Replace this brace if it's bent, broken, or missing to ensure proper alignment and stability.

Bottom guard for gas ranges. Installs at the base to protect internal components. Replace if cracked, damaged, or missing to maintain appliance integrity.

Protective bottom guard for your range. Shields internal components from debris and damage. Replace if cracked, bent, or missing for proper protection.

Replace your damaged or missing range burner box cover. This protective housing installs over the burner assembly. Ideal for cracked or broken covers.

This tech sheet is the manufacturer service guide that helps technicians and knowledgeable DIYers identify controls, wiring and specifications for service or repair tasks. It clarifies component locations and diagnostic points for accurate troubleshooting. What it does:

• Summarizes key specifications and electrical wiring diagrams used during service
• Identifies control locations and component references for faster diagnostics
• Supports proper troubleshooting by listing common failure points and test points
• Helps part orientation and connector locations during replacement

• Review the sheet fully before starting repairs to plan safe disconnection and tests
• Always disconnect power and follow lockout/tagout procedures before servicing
• Use the information as a supplement to official service manuals and safety guidelines

Mounting bracket secures oven components inside your range. Replace if bracket is bent, cracked, broken, or missing to restore proper structural support.

Replace worn felt pad gasket to prevent heat loss and reduce noise in your range. Cushions components and ensures proper sealing. Confirm fit with model number.