Kenmore Range 362.75944100 (36275944100, 362 75944100) Parts

This mounting screw secures an appliance end cap or trim piece, keeping covers and brackets fastened for safe, stable operation. It's a direct-fit replacement used when the original screw is lost, stripped, or damaged. What it does:

• Secures the end cap or trim to the appliance frame to prevent gaps and movement
• Stops rattling or vibration caused by a missing or worn screw
• Holds covers in place to protect internal components from debris
• Restores proper fit and alignment of the end cap/trim

• Disconnect power before servicing the appliance
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and tighten until snug—do not overtighten
• Replace damaged screws or threaded inserts to ensure a secure fit

Mounting bracket secures oven components inside your range. Replace if bracket is bent, cracked, broken, or missing to restore proper structural support.

Replace worn felt pad gasket to prevent heat loss and reduce noise in your range. Cushions components and ensures proper sealing. Confirm fit with model number.

Right hand side

Left hand side

This trim vent door is the finished vent trim piece that mounts to the refrigerator/freezer door opening to direct airflow and complete the exterior look. It restores proper venting appearance and helps maintain consistent airflow through the door cavity. What it does:

• Replaces damaged or cracked vent trim on the refrigerator/freezer door
• Directs internal airflow through the door vent for proper circulation
• Restores a clean, finished appearance to the door exterior
• Helps prevent debris from entering the door vent area

• Remove power to the appliance before starting work to avoid electrical or injury risk
• This part typically snaps or screws into place from the door face or interior; follow your model's service manual for exact steps
• Keep all fasteners and clips; replace any broken clips for a secure fit

Right-hand end plate for electric ranges. Replaces cracked, bent, or corroded exterior panel. Restores proper support and alignment to side components.

Left side end plate for electric ranges. Replaces cracked, broken, or missing end panels that provide structural support and finished appearance.