Kenmore Dishwasher 363.15561790 (36315561790, 363 15561790) Parts
Genuine Ge part
By: Ge
Part Number: WD01X10262
Do-It-Yourself Stories from Customers like You
I had a problem with mice behind and on top of my dishwasher had to replace the insulation blanket Lee F. • Sonoita , AZ • November 09, 2018
Pulled it out and cleaned then replaced the blanket.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD09X10004
Genuine Ge part
By: Ge
Part Number: WD12X231
Genuine Ge part
By: Ge
Part Number: WD12X338
Genuine Ge part
By: Ge
Part Number: WD12X377
Genuine Ge part
By: Ge
Part Number: WD12X378
Do-It-Yourself Stories from Customers like You
Dishes were not getting clean spray arm was not fully extending up and water hardly came out of spray arm you could open door half way and watch inside Don F. • Bellevue , NE • April 05, 2015
Replaced spray arm assembly, it's a different style than what was in the dishwasher but it's an easier style to work with. I also ordered support assembly and did not need it,spray arm assembly was all I needed.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD19X10032
This kit is used to repair a leaking pump on GE made dishwashers. For a complete pump/motor assembly get WD26X10013.
Do-It-Yourself Stories from Customers like You
Leaking water onto the floor John G. • Canmer , KY • May 28, 2015
The main conduit was broken and the pump connector had a hole in it. The pump also was showing signs of leaking. I completely disassembled the dishwasher cleaned everything and reassembled. The repair videos are a big help. Thank you.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD1X1168
Genuine Ge part
By: Ge
Part Number: WD1X1434D
Includes 12 terminals.
Do-It-Yourself Stories from Customers like You
Terminal receptacle was fried Phillip M. • Indianapolis , IN • May 12, 2015
I had to replace the 3 terminals and try to put them in the new terminal receptacle.
I replaced the lid switch because I broke the old one trying to diagnose the problem.
I found the helpful video on this site after I had already started.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD1X1439
Do-It-Yourself Stories from Customers like You
The drain solenoid on dishwasher leaked and rusted where wouldn't work Webster M. • Memphis , TN • September 19, 2014
Ordered complete solenoid kit, valve seal, and sol mounting screws. Watched repair video and it works great.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD21X10015
Do-It-Yourself Stories from Customers like You
The timer would not advance through the cycles on our hotpoint dishwasher Michael B. • Cookeville , TN • May 25, 2014
I ordered a new timer and replaced the non-working one.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD22X10024
Do-It-Yourself Stories from Customers like You
Water would not drain out completely Danny D. • Hookstown , PA • January 18, 2016
The Piston and Nut assembly replaced
Check Valve and Body and gasket replaced
Read more
More
Genuine Ge part
By: Ge
Part Number: WD22X149
Do-It-Yourself Stories from Customers like You
Triton dishwasher (2002) not draining Back I. • Strongsville , OH • July 01, 2016
I originally thought it was just accumulated dirt and sludge in the sump and the lines. I cleaned all that and it was not the cause. Saw this video...took off the filter frame and the piston & nut assembly was definitely broke (cap deteriorated to nothing). Need pliers to break it free as in the video. I accidentally ripped the screen taking off the filter frame, and saw a hole from the heating rod on top of the inlet cover so I replaced them too. Very easy replacement project once it was...
Read more
More
Genuine Ge part
By: Ge
Part Number: WD24X221
Genuine Ge part
By: Ge
Part Number: WD27X10170
Genuine Ge part
By: Ge
Part Number: WD28X10232
Do-It-Yourself Stories from Customers like You
Broken tube bottom lips Bruno W. • Sonoma , CA • October 17, 2016
The new tube would not snap on, because the plastic insulation on the dish rack swelled up, so i could not snap on the tube. So I filed of some of the swollen insulation, and now so I could snap the tube on and it works. Thanks you.
I
Read more
More