Kenmore Refrigerator 363.78677895 (36378677895, 363 78677895) Parts

This is a grommet and gasket assembly that seals the ice maker water fill tube where it passes through the freezer wall. It prevents warm air from entering the freezer compartment and stops moisture from building up around the fill tube opening. Replace this assembly if you notice frost or ice buildup around the fill tube entry point, water leaking near the ice maker, or if the existing grommet is cracked or deteriorated.

Assembly screw kit for refrigerators. Secures handles, shelf tracks, door hinges, and interior panels. Replace missing, stripped, or lost screws.

Freezer frosting over or fridge not cooling? A faulty defrost timer prevents automatic defrost cycles. DIY-friendly repair, typically takes 10-15 minutes.

This evaporator fan motor dust cap is an authentic OEM replacement part found on refrigerator and freezer fan motors. This dust cap prevents the fan motor bearing and housing from being damaged by dirt and debris. If the dust cap is cracked or broken, the fan may make loud squealing noises. If the dust cap is not removed and replaced, the fan could stop working and ultimately cause the refrigerator's temperature to be affected. To start, disconnect the power and water to the refrigerator. Remove food from the freezer so that the back panel of the freezer can be accessed to reach the fan. Remove the ice maker and set it outside the freezer. Disconnect the fan and take it out of the freezer to expose the fan's shaft and the dust cover. Pry the dust cover off and install the new one. Replace the fan and cover. Reconnect the wires and reinstall the icemaker. Put the food back in the freezer. Reconnect the power and water.The evaporator fan motor dust cap is a white plastic part that is sold individually. This dust cover is made for use in refrigerators manufactured by General Electric, Hotpoint, and Kenmore.

White plastic end cap that secures door shelf bars on refrigerator doors. Replaces broken, cracked, or missing supports. Fits both left and right sides.

Secures brackets, panels, trim, and covers inside your refrigerator. Replace this screw if stripped, missing, or damaged to restore tight assembly.

Replacement meat pan drawer for the fresh food section. Restores organized storage when original is cracked, broken, or missing. Slides into shelf rails.

White plastic frame with glass insert that covers the crisper drawer in your refrigerator. Replace if cracked, broken, or glass is shattered. Easy install.

Molded frame that supports and protects refrigerator control components. Replace if cracked, broken, or damaged to restore proper alignment and secure mounting.

Positions refrigerator door components with correct clearance for smooth swinging and level alignment. Replace if worn, cracked, or missing to restore fit.

Refrigerator not cooling or compressor clicking on and off? This compressor kit restores cooling. Requires certified technician with specialty tools.

Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.

Insulates and seals the refrigerator air duct between compartments. Replace if foam is worn, cracked, missing, or no longer sealing properly around the vent.

Fix freezer frost buildup or warm fridge with this defrost heater assembly. Melts ice from evaporator coils during defrost cycle. Moderate DIY repair.

Donut-shaped gasket creates a tight seal between refrigerator components. Replace when worn to stop minor leaks and restore secure fit. Verify fit with your model number.

The R134 Drier is an OEM part for GE refrigerators. This component plays a critical role in the refrigeration system by removing moisture and contaminants from the refrigerant, ensuring efficient cooling and preventing damage to other parts of the system. It helps maintain the purity and effectiveness of the refrigerant as it cycles through the system.

You should replace the R134 drier if it becomes clogged or damaged. Common causes of a bad drier include wear and tear over time, exposure to moisture, or contamination from other failing components in the refrigeration system.

Symptoms of a bad R134 drier include:

• Reduced cooling efficiency
• Frost buildup on the evaporator coils
• Unusual noises from the refrigeration system
• Increased energy consumption
• Refrigerator not maintaining the set temperature

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.