Kenmore Refrigerator 363.9450417 (3639450417, 363 9450417) Parts

Replace your cracked or broken refrigerator door handle channel. This structural component secures the handle assembly to the door for smooth operation.

Wire harness for refrigerators. Connects electrical components inside the unit. Replace if wires are frayed, damaged, or connections are loose or corroded.

White plastic cover for refrigerator ice maker assembly. Replaces cracked, broken, or missing covers. Installs on front of ice maker unit.

Lower crisper pan for your refrigerator. Installs in the bottom of the fresh food compartment. Replace if cracked, broken, or missing. Direct fit.

Refrigerator not cooling but freezer works? Frost buildup on back wall? Your evaporator may need replacement. Moderate difficulty repair for most models.

Replace the end cap trim on your refrigerator door handle. This decorative trim piece covers the handle end and may need replacement if cracked or missing.

This is a small clip used to secure the condenser tubing or coil in place on the back or underside of a refrigerator. It keeps the condenser components properly positioned for efficient heat dissipation. Replace this clip if it is broken or missing, which can allow condenser tubing to shift, vibrate, or contact other parts and cause rattling noises.

This baffle side discharge assembly directs dryer exhaust airflow to the side discharge port, helping maintain proper ventilation and reduce unusual noise from a damaged or misaligned baffle. Fits as a direct replacement for the original assembly. What it does

• Guides dryer exhaust air from the drum to the side discharge opening to maintain airflow.
• Helps prevent rubbing or contact between the drum and housing that can cause squeaks or scraping.
• Reduces the chance of airflow restriction that can extend drying times.
• Restores correct alignment of the exhaust path after damage or wear.

• One baffle side discharge assembly, as shown.

• Disconnect power before starting; for gas dryers, turn off the gas supply and disconnect per local codes.
• Installation typically requires removing access panels and the dryer drum or housing; have basic hand tools ready.
• Handle edges carefully and avoid forcing the part; proper alignment is needed for quiet operation and correct airflow.