Kenmore Refrigerator 363.9534781 (3639534781, 363 9534781) Parts

New ice bucket with auger assembly. The support twist I ordered did not come and is back orderd. . Due later. The ice dispencer works fine without it. Read more

The replacement was made to fit various models. None of the instructions really fit my model. Ended up spending less time actually replacing it than reading the instructions. Took about 15 minutes. Needed a zip tie to hold the wires to back, otherwise the ice drawer would not shut. Works great, faster than the original, makes 8 cubes every 40 minutes. Ice feeler seems more flimsy than the old design which was a lift up wire. New design is a plastic paddle with an on off switch, which could... Read more

I bought a condo, and did not realize the freezer shelves were broken. Once I moved in, I realized several shelves were held up by string.......I knew I couldn't use it effectively that way, and I wasn't ready to buy a new refrigerator, so I googled appliance parts and found this site. It was easy to find the part I needed, and I did check other sites, and found this one to be the cheapest total cost (price plus shipping). I received my shelving parts very quickly, and can now use my freezer... Read more

Replaced the cover over the ice maker switch as you recommended works like new. Thank you for diagnosing my problem. Read more

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

Ordered parts and watched the video. Read more

Got replacement parts. Support only held on by two screws. Read more

Buy 2 new drawers replace its Read more

I did have to dig out the tiny old broken pieces of glass from the front rubber edging with a knife blade. I tried both a screwdriver and needle nose pliers, but they were shredding the edge. Then I just popped it on and laid the glass in the slots. Super easy! Read more