Kenmore Washer 417.27182701 (41727182701, 417 27182701) Parts

This OEM replacement part is a drive motor for washers. The drive motor is the main engine that propels the washer tub to spin and perform its primary function of washing clothes. Over time, a drive motor can lose power or stop working altogether due to excessive wear and tear. If the washer is no longer spinning or not working as efficiently as it once did, the drive motor will need to be replaced. Thankfully, replacing this part is a relatively easy fix.To begin, start by unplugging the washer. Once unplugged, move the washer away from the wall to gain access to the back panel. Uninstall the back panel by removing the mounting screws. Once removed, gain access to the drive motor and remove the screws that attach it to the washer. After unthreading the screws, pull the drive motor out of its place and position the new motor in its original position. Fasten the mounting screws and make sure the motor is securely attached. This genuine replacement part is sold individually and is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore brand washers.

Outer door panel that replaces a damaged or worn outer door surface, restoring the appliance's finished exterior and protecting inner door components. Ideal when the exterior is dented, scratched, or cosmetically damaged. What it does

• Provides the finished exterior surface for the appliance door and protects internal door components from damage.
• Restores appearance after dents, scratches, rust spots, or cracked paint.
• Re-establishes mounting surfaces and edge trim where tabs or attachment points are intact.
• Helps prevent further corrosion or moisture intrusion into the door assembly.

• Disconnect power (and water, if applicable) and follow before starting; use proper PPE.
• Door removal and panel replacement often require basic hand tools; save and reuse original screws, handles, and trim unless replacements are supplied.
• Transfer any hardware, insulation, or inner-door pieces from the old door to the new panel as required.
• Large panels can be awkward—have a second person assist to avoid dropping or bending the panel.

This 115V water inlet valve controls water flow to the refrigerator's dispenser and ice maker, restoring reliable water supply when the valve fails. Designed to replace a faulty solenoid valve and stop leaks or no-water issues. What it does

• Opens and closes water flow to the ice maker and door dispenser when energized.
• Commonly replaces valves that hum, leak, or fail to allow water flow.
• Stops intermittent or no-water conditions caused by a stuck or electrically failed valve.
• Works with the fridge's control signals to deliver water only when needed.

• One 115V water inlet (solenoid) valve as shown.

• Disconnect power and shut off the household water supply before replacing the valve.
• Verify electrical connections and water line fittings are tight and leak-free after installation.
• Handle inlet fittings carefully to avoid damage; use appropriate tools and avoid overtightening.