Kenmore Washer 417.40412700 (41740412700, 417 40412700) Parts

Lower spring tub sleeve for washers. Protects and guides the suspension spring connection to the tub. Replace if cracked, worn, or missing.

Upper spring tub sleeve for washers. This bushing cushions the suspension spring connection to the tub. Replace if worn, cracked, or missing.

Replacement handle and trim for washer dispenser drawer. Installs on the front of the detergent drawer assembly. Needed when original is cracked or broken.

Support plate for washer components. Mounts internally to secure parts in place. Replace if cracked, bent, or missing to restore proper structural support.

Rubber isolator that cushions vibrating components in your washer. Replace if cracked, worn, or missing to restore proper mounting and reduce noise.

Front tub counterweight for washers. Adds stability during spin cycles. Replace if cracked, broken, or missing to prevent excessive vibration.

Washer won't start or stops mid-cycle? A faulty lid switch is often the cause. This safety switch tells your washer the lid is closed. 15-30 minute fix.

Fix a washer that won't start or agitate with this lid switch replacement. Common fix when your washer won't run with the lid closed. Moderate DIY repair.

Replacement mounting nut for washers and laundry appliances. Secures internal components and panels. Order if original nut is stripped, missing, or broken.

Front control panel for washers that houses console buttons and display. Replaces cracked, damaged, or worn panels to restore appearance and access.

This replacement overflow shield directs excess water away from sensitive components to help prevent leaks and water damage in the appliance. It restores proper drainage protection when the original shield is cracked, warped, or missing. What it does:

• Channels overflow or stray water away from critical areas to reduce risk of leaks
• Replaces damaged, cracked, or missing overflow shielding
• Helps maintain proper drainage pathways and component protection
• Commonly used when you see water pooling or dripping near the shielded area

• One overflow shield

• Inspect surrounding seals and fasteners; replace any that are damaged before installing the new shield
• Installation typically requires basic hand tools; secure the shield in the original mounting points
• Disconnect power to the appliance before starting work and restore power only after reassembly

Suspension bushing for washer tub assembly. Replaces worn, cracked, or missing bushings that cause excessive noise or tub movement during cycles.

Replacement mounting screw for securing appliance panels, brackets, and internal components. Needed when original fasteners are stripped, missing, or lost.