Kenmore Dryer 417.64182300 (41764182300, 417 64182300) Parts

The Terminal Block is an OEM replacement part for Frigidaire clothes dryers. It is the part the power cord connects to. This kit includes 3 screws and 3 terminals.

Causes of a bad terminal block can include damage from age, overheating from worn wires or loose connections, or improper installation during manufacturing.

Symptoms of a bad terminal block include:

• The dryer not powering on
• Intermittent heating issues
• Loose, frayed, or damaged wires

This Frigidaire OEM replacement part is also compatible with Electrolux, Gibson, Kelvinator, and some Kenmore models.

This wiring clip secures a refrigerator's wire harness to the cabinet or components to prevent chafing and keep wires organized. It helps maintain safe routing and reduces strain on electrical connections. What it does

• Holds wiring harness in place to prevent rubbing against sharp edges or moving parts
• Keeps wires organized to reduce the risk of pinching or accidental disconnection
• Helps prevent intermittent electrical faults caused by loose or strained wiring
• Commonly used near compressor, fan, control box, or rear cabinet areas

• Install by snapping the clip onto the cabinet flange or component and routing the harness through the retainer
• Disconnect power before accessing electrical components or wiring
• Inspect surrounding wiring and insulation; replace any damaged wire or harness tape before reinstalling the clip

This idler arm assembly is the dryer belt tensioner that maintains correct belt tension for smooth drum rotation. Replacing a worn idler helps stop belt slip and restores normal drum movement. What it does:

• Keeps the dryer drive belt tensioned so the drum turns properly
• Prevents belt slipping that can cause reduced or no tumbling
• Reduces idler-related noise such as squealing or grinding
• Helps avoid premature belt wear or fraying caused by a loose idler

• Disconnect power (and gas supply if applicable) before starting any repair
• Handle sharp edges carefully and wear gloves and eye protection
• Verify belt routing and tension when reinstalling the belt and idler

This is a painted 1/4-20 machine screw used to secure appliance panels and components, restoring proper fit and stopping movement. It replaces small hardware lost or worn during repairs. What it does:

• Fastens panels, brackets, or assemblies with a 1/4-20 threaded hole
• Helps stop rattling, vibration, or loose-fitting parts
• Restores secure mounting after service or part replacement
• Matches finish to keep visible areas looking consistent

• Disconnect power and move the appliance to a safe, stable work area before servicing
• Use the matching screwdriver or socket; install by hand first to avoid cross-threading
• Tighten until snug—do not overtighten to prevent stripped threads or damaged parts
• Replace with the same size and finish screw; inspect threads before forcing