Kenmore Dryer 417.90042991 (41790042991, 417 90042991) Parts

Secures the dryer door to the cabinet and provides a smooth pivot point. Replace this hinge if bent, worn, or broken to restore proper door alignment.

Secures panels, brackets, and trim on appliances. Replace when missing, stripped, or damaged to restore a tight, rattle-free fit and proper alignment.

Threaded fastener that secures and spaces dryer components. Replace if the original spacer screw is missing, stripped, or damaged during repairs.

Replacement screw that secures panels and components in dryers, washers, and ranges. Needed when original fasteners are missing, stripped, or worn.

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

Mounting screw secures panels, trim, or brackets in dryers, washers, and ranges. Replace lost, stripped, or corroded screws to restore stability.

White plastic plug insert that covers unused openings on your dryer. Keeps out dust and debris while restoring a clean finish. Replace if cracked or missing.

Hex washer head ,10-32 x 0.375. Ground

Dryer not heating or shutting off early? The safety thermostat monitors temperature and cuts power when it gets too hot. Tests quickly with a multimeter.

White plastic dome plug insert for dryer. Covers exposed holes on dryer cabinet where pedestal or stacking kit was removed. Replaces missing or broken plugs.

Internal heat duct hose that routes hot air through your dryer drum. Replace if cracked, kinked, torn, or disconnected to restore proper airflow.

White top panel for stackable dryers. Replaces cracked, damaged, or discolored panels. Installs on top of dryer unit to restore appearance and protect.

Control board mounting bracket for dryers. Secures the electronic control board to the dryer frame. Replace if bracket is cracked, bent, or missing.

Secures the blower housing in your dryer. Replace if broken, loose, or causing rattling noises during operation. Verify fit with your model number.

Dryer burner bracket secures the gas burner assembly in place. Replace if bracket is bent, broken, or corroded, preventing proper burner alignment.