Kenmore Dryer 417.94082500 (41794082500, 417 94082500) Parts

Secures the fan housing to its mounting points. Replace if the clip is broken, missing, or worn to eliminate rattles and prevent air leaks in your dryer.

Stacking kit bracket module that secures your dryer on top of a washer. Replaces cracked, broken, or missing brackets to restore safe stacking.

Internal heat duct hose that routes hot air through your dryer drum. Replace if cracked, kinked, torn, or disconnected to restore proper airflow.

This is a small translucent light pipe that channels light from the circuit board to the front control panel, allowing indicator lights to be visible during dryer operation. It fits into the control panel housing and directs LED or bulb light to the display area. Replace this part if your dryer's indicator lights appear dim, unlit, or inconsistent even though the control board is functioning properly.

Fix error codes or unresponsive controls with a new dryer electronic control board. Restores cycle selection and timing. DIY install in under 1 hour.

Dryer mounting bracket that secures internal components to the cabinet frame. Replace if bent, broken, or rusted to restore proper fit and alignment.

Replacement coupler bushing for your dryer. This small rubber component connects the motor to the drum drive system. Order a new one if worn or missing.

This replacement plug seals an unused opening on compatible appliances to help prevent moisture, dirt and pests from entering and to restore the original appearance and fit. It's a simple, low-cost part for routine repairs. What it does

• Seals an access hole or unused opening to help keep moisture and debris out
• Helps block pests and contaminants from entering the appliance cabinet
• Secures wiring or tubing routing where a protective cap is required
• Restores original fit and finish at the plug location

• One replacement plug

• Disconnect power to the appliance before beginning any work
• Remove the access panel or trim necessary to reach the plug location
• Press the plug into place; small hand tools may help for snug seating
• Inspect surrounding gaskets and panels for damage while installing

Secures internal dryer components and assemblies. Replacement needed when bracket is cracked, broken, or missing to restore proper fit and alignment.

Replacement use and care guide manual for your dryer. Needed when original manual is lost, damaged, or missing. Provides operating instructions.

Technical data sheet for your dryer. Provides specifications, wiring diagrams, and installation details. Replace if lost, damaged, or illegible.

Replacement pipe cap for dryers. Covers and seals pipe openings in your dryer's internal system. Order a new cap if yours is cracked, broken, or missing.

This mounting bracket secures internal components in place to keep appliance parts aligned and stable during normal use. Replacing a damaged bracket restores proper fit and support for affected assemblies. What it does:

• Provides structural support for internal panels or assemblies to prevent shifting and noise
• Helps maintain proper alignment of moving parts to reduce wear
• Stops rattling or vibration caused by a broken or bent bracket
• Keeps connected components securely attached after repair or reassembly

• One mounting bracket

• Disconnect power and water before starting any repair
• Inspect surrounding fasteners and hardware; replace any stripped screws for a secure fit
• Use proper-size tools to avoid damage to mounting holes or nearby components