Kenmore Washer Dryer Combo 417.98988840 (41798988840, 417 98988840) Parts

This holder secures components inside your dryer. Replace if the original is cracked, broken, or missing to properly mount internal parts and accessories.

Door spacer that maintains proper clearance between the dryer door and cabinet. Replace if cracked, broken, or missing to ensure correct door alignment.

A single replacement screw fastener used to secure trim, panels, or internal components. Fits specific Frigidaire appliance locations to restore proper fastening and alignment where factory hardware is missing or damaged. What it does:

• Secures plastic trim, brackets, or metal panels in refrigerators and freezers
• Restores proper alignment and prevents rattling or loose parts
• Replaces stripped, corroded, or lost hardware to maintain appliance function
• Works wherever the original factory screw was specified

• One replacement screw

• Use the correct screwdriver or bit to avoid damaging the screw head
• Do not overtighten; snug until seated to prevent cracking plastic or stripping threads
• Replace only with the exact factory part for proper fit and function
• Unplug the appliance or turn off power first if working near electrical components

Almond-colored door handle for dryer models. Installs on the outer door panel. Replace if your handle is cracked, broken, or missing for secure access.

This timer shield is a molded cover that protects the appliance's timer/control mechanism from dust, debris and accidental contact, helping the timer operate reliably and extending component life. What it does:

• Covers the timer assembly to shield electrical contacts and the timer shaft from contaminants
• Reduces risk of shorting from debris or accidental contact with the timer
• Helps prevent intermittent timer operation caused by dirt or physical interference
• Appropriate for repairs where the original timer cover is cracked, missing, or damaged

• Disconnect power to the appliance before beginning any service
• Remove any control knobs or bezel needed to access the timer, then snap or screw the shield into place per the original orientation
• Inspect surrounding components (timer mounting, wiring) while the control is exposed; replace damaged parts as needed